最新色国产精品精品视频,中文字幕日韩一区二区不卡,亚洲有码转帖,夜夜躁日日躁狠狠久久av,中国凸偷窥xxxx自由视频

Abstract:The characteristics of Ni-H cell and the compositions, preparation and processing technique of rare earth hydrogen storage materials applied to Ni-H cell are introduced in this paper. The effect of the additives on the comprehensive properties of the LaNi_5 based alloy electrode and the future application and development of Ni-H cell are also described.

Abstract:The present development of the determination of gases in metals have been reviewed. The applications of reduced fusion, particularly inert-gas fusion methods, the research of determination methods of gases in hyperpure metals, the influence of sample treatment on determination results, etc., are covered and discussed in brief. The standard methods, standard samples and commercial gas-analyzing equipment are also involved.

Abstract:用透射電子顯微術和X射線能譜術研究了Ti_3Al-11Nb(Ti-12.5wt%Al-21wt%Nb)合金熱鍛棒材在熱處理過程中的相變特征。結果表明,合金在1100℃加熱后緩冷到室溫的樣品其組織由α_2+β相組成。與α_2相相比,β相明顯地表現出Al含量低而Nb含量高。1200℃油淬樣品的組織由α_2+B2相組成,二相含量大致相近。1200℃水淬樣品由單一的B2相組成。水淬并經750℃時效的樣品中析出兩種形態的α_2相:首先由晶界析出的較粗的α_2相以及在晶內普遍析出的彌散的α_2相。

Abstract:報導了用熔融定向凝固工藝制備的有織構YBCO超導體的微結構變化及其特性。將YBCO坯料加熱到1050—1120℃,分解成Y_2BaCuO_5(211)和液相(Ba-Cu-O),然后在50℃/cm的溫度梯度下,慢速移動樣品重新合成YBCO超導體。X光衍射結果證實,熔融樣品具有較強的c軸織構。掃描電鏡觀察表明,熔融后晶粒形貌發生了顯著變化:YBCO晶粒由原燒結塊材的隨機排列變?yōu)橐恢氯∠蚧蚓植咳∠蚺帕械钠瑺罱M織。熔融樣品的J_c(77K,0T,>10000 A/cm~2)值比燒結塊材J_c(750A/cm~2)

Abstract:用透射電子顯微鏡觀察了TC6鈦合金在高溫退火過程中形成的亞晶(Subgrain)。合金經850℃,920℃退火后爐冷和空冷,在初生α相晶粒內形成亞晶,多為成簇分布的狹長形狀,亞晶的數量隨退火后冷卻速度的增加而減少。亞晶界(Subgrain boundary)是由位錯構成的,亞晶的形成是多邊化(polygonization)的結果。

Abstract:The process to manufacture composite material Ag-Cu-C with multimillion-fibrous structure has been investigated by indirect reapated extrusion-drawing method. The results show that, with increasing the number of extrusion, the extrusion coefficient and specific resistance increase, but ultimate tensile strength and elongation at room temperature decrease. A composite wire, which consists of 1067857 homogeneous distributed fibres of Ag, Cu and C, arranged at intervals has been prepared.

Abstract:介紹了耐蝕Ti-0.3Mo-0.8Ni合金實驗室試驗及工業性試驗研究的結果,報導了該合金的物理、機械和腐蝕性能。

Abstract:建立了一套脈沖臨界電流測量裝置,脈沖電流大小在0—500 A之間可調,脈沖電流上升時間在0.2—10 ms之間可調,失超電壓判據可以達到微伏量級。對于電接點發熱不明顯的樣品,用直流法和脈沖法測定的臨界電流可以獲得相同的結果。用本裝置,在YBCO塊樣品上測到了高的臨界電流密度數據:77K,1T下J_c>7×10~4A/cm~2,4T下J_c>3.5×10~4A/cm~2。

Abstract:A recoverable method for permeability of the titanium filter blocked by carbon particles is investigated. Two groups of the samples with the average blockage degree of 55% and 95%, respectively, are cleaned by supersonics or immersed in K_2Cr_2O_7 lotion. The recoverable permeability of these filter are determined later. The test demonstrates that the blockage degree, treating process, lotion formulation and the treating time all have impacts on the recoverability of permeability of titanium filter. It is shown that the treatment by supersonics has the best result, and the less the blockage by carbon particles, the easier for the recovery of the permeability of titanium filter.

Abstract:This article reviews the properties of 1, 10-phenanthroline (phen) and its metal chelates, and describes the practical applications of phen in the analytical chemistry.

Abstract:This review deals with the present applications of multicomponent complex in spectrophotometric analysis of Zr and Hf. The work for enhancing the sensitivity and improving selectivity of the process are cited.

Abstract:Some major refractory metal (W and Mo ) manufacturers, main products, processing techniques and facilities in former USSR are introduced. A preliminary evaluation is also given in this paper.