6C、M23C6的簡單和復雜碳化物，導致了位錯的塞積。深冷處理24 h后試樣的幾何必須位錯（GND）密度增大，當24 h循環處理2次后，GND密度顯著降低。此外，深冷處理導致Inconel 617合金的旋轉立方織構和旋轉銅織構轉變?yōu)辄S銅織構、P織構、高斯織構。;The relationship of microstructure evolution with subzero treatment time and number of Inconel 617 alloy was studied. The results indicate that subzero treatment has an obvious influence on the microstructure of Inconel 617 alloy. With the increase in subzero treatment time, the grain size decreases. With the increase in subzero treatment number, the grain size increases gradually, and the high stress is retained at the boundaries of the refined grains. The lattice constant varies inversely with the grain size. The simple and complex carbides of MC, M6C and M23C6 are precipitated from the samples after subzero treatment, which leads to the accumulation of dislocations. The geometrically necessary dislocation density of the samples increases after subzero treatment for 24 h, and decreases significantly with two times of subzero treatment for 24 h. In addition, after subzero treatment, the rotated cube texture and rotated copper texture transform to brass texture, P texture and goss texture."/>