3的摩爾比由1.5變?yōu)?.5，納米銀線直徑先減小后增加；當摩爾比為6.0時，納米銀線直徑最小，為77.7 nm。納米銀線直徑由106.1 nm減小為77.7 nm，熔化溫度隨之減小，最低為281.2 ℃。單晶納米銀線長徑比由6變?yōu)?2時，屈服強度逐漸由0.63 GPa提升至0.83 GPa。單晶納米銀線熔化溫度隨長徑比增加而減小，由690 K變?yōu)?57 K。PVP與AgNO3的摩爾比為6.0是合成銀線的最佳條件，長徑比大的納米銀線具有良好的抵抗變形的能力。;Silver nanowires with different aspect ratios were prepared by adjusting the molar content of polyvinylpyrrolidone (PVP) through the liquid-phase reduction method. X-ray diffractometer, scanning electron microscope, UV-Vis spectrophotometer, simultaneous thermal analyzer, and transmission electron microscope were used to characterize the phase composition, microstructure, light absorption properties, thermal decomposition, and crystal structures of the silver nanowires, and the molecular dynamics was used to simulate the stretching and melting processes of single-crystal silver nanowires. Result shows that the silver nanowires are mainly composed of face-centered cubic silver. When the molar ratio of PVP to AgNO3 changes from 1.5 to 7.5, the diameter of silver nanowires firstly decreases and then increases, and the minimum diameter of nanowires is 77.7 nm when the molar ratio is 6.0. With decreasing the diameter of silver nanowires from 106.1 nm to 77.7 nm, the melting temperature is decreased, and the lowest melting temperature is 281.2 °C. The yield strength is gradually increased from 0.63 GPa to 0.83 GPa with increasing the aspect ratios of silver nanowires from 6 to 72. The melting temperature of single-crystal silver nanowires is decreased from 690 K to 657 K with increasing the aspect ratio. Therefore, the molar ratio of 6.0 is the optimal condition to synthesize silver nanowires, and the silver nanowires with a large aspect ratio have good resistance to deformation."/>