-1條件下的熱變形行為，利用動態材料模型構建了鈦鋁復合板熱加工圖，并基于熱加工圖進行了鈦鋁復合板熱軋工藝驗證實驗。結果表明：鈦鋁復合板屬于正應變速率敏感材料；在熱加工圖中變形溫度為420~460 ℃、應變速率為1.6~6.3 s-1時，功率耗散效率達到0.64~0.72，該區域?qū)?yīng)的工藝參數適合進行鈦鋁復合板熱軋；熱軋后實驗板材界面結合良好，具有良好的力學性能和鈑金成形性能。鈦鋁復合板在熱軋過程中的變形機制為：變形抗力低、流動快的鋁層在自身發生塑性變形的同時牽引著鈦層一起發生塑性變形，其中鋁層是熱變形，鈦層為冷變形。;The hot deformation behavior of explosive welded titanium-aluminum (Ti-Al) clad plate was studied by isothermal compression tests at 300~500 °C with strain rates of 0.1~10 s-1 on Gleeble 3500 simulated machine. The hot processing map was developed on the basis of experimental data using the principles of dynamic materials model, and the verification experiment of hot rolling process of Ti-Al clad plate was carried out based on the hot processing map. The results show that Ti-Al clad plate is a kind of positive strain rate sensitive material. The efficiency of power dissipation of 0.64~0.72 can be observed at 420~460 °C with strain rate of 1.6~6.3 s-1 in the hot processing map, and the process parameters of this region are suitable for the hot rolling of Ti-Al clad plate. After hot rolling, the interfaces of the Ti-Al clad plates are well bonded, and the plates have excellent mechanical property and good sheet metal forming property. The deformation mechanism of Ti-Al clad plate in the hot rolling process is as follows: the Al layer with low deformation resistance and fast flow can produce plastic deformation, and at the same time it can pull the Ti layer together to produce plastic deformation; in this process, the Al layer is hot deformation while the Ti layer is cold deformation."/>