-1條件下進行了熱壓縮試驗，研究了雙相Mg-Li合金的熱加工性能、顯微組織演變和相組成。建立了整合加工和α-Mg相含量的最佳熱加工窗口。結果表明，所建立的Arrhenius本構模型能夠準確預測軟化過程中的應力流動行為。通過對合金顯微組織的觀察，發現動態回復（DRV）、動態再結晶（DRX）和α-Mg相變是主要的軟化機制。α-Mg相以球化和α-Mg相內析出的形式轉變?yōu)棣?Li相，尤其是在300 ℃以上相變現象顯著。同時，DRX行為容易在β-Li相中發生，而在α-Mg相中會被抑制?；趧?dòng)態材料模型和微觀結構分析，獲得最佳加工窗口：溫度300?350 ℃/0.1?1 s-1和溫度250 ℃/0.1 s-1。"/>

最新色国产精品精品视频,中文字幕日韩一区二区不卡,亚洲有码转帖,夜夜躁日日躁狠狠久久av,中国凸偷窥xxxx自由视频

+高級檢索
雙相Mg-Li合金的 α→β 相變及熱加工性能研究
作者:
作者單位:

1.北京科技大學 機械工程學院，北京 100083;2.金屬輕量化成形制造北京市重點實驗室，北京 100083

作者簡介:

通訊作者:

中圖分類號:

基金項目:

國家自然科學基金項目（面上項目，重點項目，重大項目）,


Hot Workability of Dual-Phase Mg-Li Alloy with α→β Trans-formation at Elevated Temperatures
Author:
Affiliation:

1.School of Mechanical Engineering, University of Science and Technology Beijing, Beijing 100083, China;2.Beijing Key Laboratory of Lightweight Metal Forming, Beijing 100083, China

Fund Project:

National Natural Science Foundation of China (52175285, 52161145407); Fundamental Research Funds for the Central Universities (FRF-BD-20-08A, FRF-AT-20-09, FRF-TP-20-009A2)

  • 摘要
    • |
  • 圖/表
    • |
  • 訪問統計
    • |
  • 參考文獻
    • |
  • 相似文獻
    • |
  • 引證文獻
    • |
  • 資源附件
    • |
  • 文章評論
    摘要:

    在溫度為250?400 ℃、應變速率為0.1?10 s-1條件下進行了熱壓縮試驗，研究了雙相Mg-Li合金的熱加工性能、顯微組織演變和相組成。建立了整合加工和α-Mg相含量的最佳熱加工窗口。結果表明，所建立的Arrhenius本構模型能夠準確預測軟化過程中的應力流動行為。通過對合金顯微組織的觀察，發現動態回復（DRV）、動態再結晶（DRX）和α-Mg相變是主要的軟化機制。α-Mg相以球化和α-Mg相內析出的形式轉變?yōu)?i>β-Li相，尤其是在300 ℃以上相變現象顯著。同時，DRX行為容易在β-Li相中發生，而在α-Mg相中會被抑制。基于動態材料模型和微觀結構分析，獲得最佳加工窗口：溫度300?350 ℃/0.1?1 s-1和溫度250 ℃/0.1 s-1。

    Abstract:

    Hot workability, microstructure evolution, and phase composition of dual-phase Mg-Li alloy were investigated via hot compression test at 250?400 °C with strain rates of 0.1?10 s-1. The optimum hot workability window integrating processing and α-Mg content maps was established. Results show that the established Arrhenius constitutive model can accurately predict the stress flow behavior during work softening. In addition, the microstructure of the alloy shows that dynamic recovery (DRV), dynamic recrystallization (DRX) and α-Mg phase transformation are the main softening mechanisms. α-Mg phase is transformed into β-Li phase in forms of both spheroidization and internal precipitation of α-Mg phase, especially above 300 °C. Meanwhile, the DRX process can easily occur in β-Li phase, whereas in the α-Mg phase it is retarded. Based on the dynamic materials model and microstructure analysis, the optimal processing window can be obtained as 300?350 °C/0.1?1 s-1 and 250 °C/0.1 s-1.

    參考文獻
    相似文獻
    引證文獻
引用本文

馮英豪,孫朝陽,徐斯諾,朱南洋,王青磊,王春暉.雙相Mg-Li合金的 α→β 相變及熱加工性能研究[J].稀有金屬材料與工程,2023,52(4):1227~1237.[Feng Yinghao, Sun Chaoyang, Xu Sinuo, Zhu Nanyang, Wang Qinglei, Wang Chunhui. Hot Workability of Dual-Phase Mg-Li Alloy with α→β Trans-formation at Elevated Temperatures[J]. Rare Metal Materials and Engineering,2023,52(4):1227~1237.]
DOI：10.12442/j. issn.1002-185X. E20220026

復制
文章指標
  • 點擊次數:
  • 下載次數:
  • HTML閱讀次數:
  • 引用次數:
歷史
  • 收稿日期:2022-09-21
  • 最后修改日期:2023-04-03
  • 錄用日期:2022-11-09
  • 在線發布日期: 2023-04-28
  • 出版日期: 2023-04-25