最新色国产精品精品视频,中文字幕日韩一区二区不卡,亚洲有码转帖,夜夜躁日日躁狠狠久久av,中国凸偷窥xxxx自由视频

+高級檢索
超音速火焰噴涂WC-12Co、WC-10Co4Cr和Cr3C2-25NiCr涂層在不同介質中摩擦行為研究
作者:
作者單位:

1.江西理工大學;2.崇義章源鎢業股份有限公司

作者簡介:

通訊作者:

中圖分類號:

基金項目:

國家級大學生創新創業訓練計劃項目(202010407014)；江西省教育廳自然科學基金面上項目(GJJ200807)；江西省主要學術和技術帶頭人培育計劃青年人才項目(20212BCJ23005)


Friction Behavior of WC-12Co、WC-10Co4Cr and Cr3C2-25NiCr coatings under different media*
Author:
Affiliation:

Fund Project:

National innovation and entrepreneurship training program for college students (202010407014); General project of Natural Science Foundation of Jiangxi Provincial Department of Education (gjj200807); Young talent project of Jiangxi Province"s major academic and technical leaders cultivation program (20212bcj23005)

  • 摘要
    • |
  • 圖/表
    • |
  • 訪問統計
    • |
  • 參考文獻
    • |
  • 相似文獻
    • |
  • 引證文獻
    • |
  • 資源附件
    • |
  • 文章評論
    摘要:

    為了研究硬面涂層在不同介質中的摩擦行為，以WC-12Co、WC-10Co4Cr和Cr3C2-25NiCr硬面材料為原料，采用超音速火焰噴涂制備得到了三種不同成分的硬面涂層。通過顯微硬度計、摩擦磨損儀和掃描電鏡等對涂層性能分析，結果表明，涂層中的孔隙率和粘結相的含量密切相關，當粘結相含量為12wt.%（Co）時，其孔隙度為1.11%；粘結相含量為14wt.%（CoCr）時，其孔隙度為0.98%；粘結相含量為25wt.%（NiCr）時，其孔隙度降低為0.92%。空氣中，WC-10Co4Cr的硬度最高，其摩擦系數最?。籆r3C2-25NiCr的硬度最小，其摩擦系數最大。1mol/L HCl的環境中，NiCr的耐腐蝕性能最好，使Cr3C2-25NiCr涂層的摩擦系數穩定；而純Co和CoCr的耐腐蝕性能較差，使WC-10Co4Cr和WC-12Co涂層的摩擦系數呈現出波浪狀的變化規律。1mol/L NaOH的環境的摩擦過程中，硬質相的腐蝕會使涂層表面的硬度下降，使摩擦系數增加。

    Abstract:

    In order to study the friction behavior of hard surface coatings under different media, the coatings were prepared by HVOF with WC-12Co, WC-10Co4Cr and Cr3C2-25NiCr materials as raw materials. The properties of the coatings were analyzed by micro-hardness tester, wear tester, scanning electron microscope and so on. The results showed that the porosity of the coating was closely related to the content of the binder phase. In air, WC-10Co4Cr had the highest hardness and the lowest friction coefficient, while Cr3C2-25NiCr had the lowest hardness and the highest friction coefficient. In the environment of 1mol/L HCl, the best corrosion resistance of NiCr binder made the friction coefficient of Cr3C2-25NiCr coating stable, and the poor corrosion resistance of pure Co and CoCr made the friction coefficient of WC-10Co4Cr and WC-12Co coatings with high and low fluctuations. In the friction process under 1mol/L NaOH environment, the corrosion of hard phase could reduce the hardness and increase the friction coefficient.

    參考文獻
    相似文獻
    引證文獻
引用本文

羅鑫,王韶毅,洪源昆,吳佳逸,駱宛卿,羊求民.超音速火焰噴涂WC-12Co、WC-10Co4Cr和Cr3C2-25NiCr涂層在不同介質中摩擦行為研究[J].稀有金屬材料與工程,2022,51(12):4682~4688.[Xin Luo, Shaoyi Wang, Yuankun Hong, Jiayi Wu, Wanqing Luo, Qiumin Yang. Friction Behavior of WC-12Co、WC-10Co4Cr and Cr3C2-25NiCr coatings under different media*[J]. Rare Metal Materials and Engineering,2022,51(12):4682~4688.]
DOI：10.12442/j. issn.1002-185X.20211034

復制
文章指標
  • 點擊次數:
  • 下載次數:
  • HTML閱讀次數:
  • 引用次數:
歷史
  • 收稿日期:2021-11-23
  • 最后修改日期:2022-02-21
  • 錄用日期:2022-03-07
  • 在線發布日期: 2023-01-19
  • 出版日期: 2022-12-30