2}孿晶面形核,并不斷消耗1α相而長大。TB17鈦合金的時效特征與其他β型鈦合金相似。TB17鈦合金的時效響應快,顯微硬度隨著時效溫度升高呈現出先增加后降低的趨勢,在450 ℃時效處理下硬度達到最大。"/>

最新色国产精品精品视频,中文字幕日韩一区二区不卡,亚洲有码转帖,夜夜躁日日躁狠狠久久av,中国凸偷窥xxxx自由视频

+高級檢索
TB17鈦合金在等溫時效過程中的相析出行為
作者:
作者單位:

1.南昌航空大學 材料科學與工程學院,江西 南昌 330063;2.南昌航空大學 江西省航空材料表面技術工程研究中心,江西 南昌 330063;3.中國航發北京航空材料研究院 先進鈦合金航空科技重點實驗室,北京 100095

作者簡介:

通訊作者:

中圖分類號:

基金項目:

國家自然科學基金項目


Phase Precipitation Behavior of TB17 Titanium Alloy During Isothermal Aging Process
Author:
Affiliation:

1.School of Materials Science and Engineering, Nanchang Hangkong University, Nanchang 330063, China;2.Jiangxi Provincial Engineering Research Center for Surface Technology of Aeronautical Materials, Nanchang Hangkong University, Nanchang 330063, China;3.Aviation Key Laboratory of Science and Technology on Advanced Titanium Alloys, AECC Beijing Institute of Aeronautical Materials, Beijing 100095, China

Fund Project:

National Natural Science Foundation of China (51764041)

  • 摘要
  • |
  • 圖/表
  • |
  • 訪問統計
  • |
  • 參考文獻
  • |
  • 相似文獻
  • |
  • 引證文獻
  • |
  • 資源附件
  • |
  • 文章評論
    摘要:

    采用X射線衍射、掃描電子顯微鏡、透射電子顯微鏡和硬度測試分析了新型超高強韌鈦合金TB17在等溫時效過程中析出相的演變及時效響應。結果表明:該合金在350 ℃時主要發生β→β+ω相變,ω相為細小的顆粒。在450 ℃下進行時效處理時,α相通過ω相輔助形核的方式形核長大。在550和650 ℃時主要發生β→β+α相變,α相為片層狀。在該溫度范圍內長時間進行時效處理的TB17合金存在2種類型α相,滿足Burgers關系的1α相和不滿足Burgers關系的2α相。其中2α相為孿晶α相,在1α相內部{102}孿晶面形核,并不斷消耗1α相而長大。TB17鈦合金的時效特征與其他β型鈦合金相似。TB17鈦合金的時效響應快,顯微硬度隨著時效溫度升高呈現出先增加后降低的趨勢,在450 ℃時效處理下硬度達到最大。

    Abstract:

    The precipitation phase evolution and the aging response of TB17 titanium alloy, a new titanium alloy with ultra-high strength and toughness, were studied by X-ray diffraction, scanning electron microscope, transmission electron microscope, and Vickers hardness tests during isothermal aging process. The results show that ββ+ω phase transformation mainly happens at 350 °C, and the precipitated phase ω is the shape of fine granular. After aging treatment at 450 °C, the α phase is nucleated through the assistance nucleation of ω phase. The phase transformation of ββ+α occurs at 550 and 650 °C and the α phase exhibits lamellar structure. However, there are two types of α phase precipitated after aging at 550 and 650 °C for long time: the Burgers α (Type 1α) phase which satisfies the Burgers orientation relationship and the Type 2α phase which does not satisfy the Burgers orientation relationship. The Type 2α phase is a twin crystal phase nucleated on the {102} twin plane inside the Burgers α phase. The aging characteristic of TB17 titanium alloy is similar to that of most β type titanium alloys. The aging response of TB17 titanium alloy is fast. The Vickers hardness of TB17 titanium alloy is increased firstly, reaching the maximum value at 450 °C, and then decreased with increasing the aging temperatures.

    參考文獻
    相似文獻
    引證文獻
引用本文

羅軍明,朱鴻昌,朱知壽,徐吉林,李明兵.TB17鈦合金在等溫時效過程中的相析出行為[J].稀有金屬材料與工程,2021,50(11):3862~3870.[Luo Junming, Zhu Hongchang, Zhu Zhishou, Xu Jilin, Li Mingbing. Phase Precipitation Behavior of TB17 Titanium Alloy During Isothermal Aging Process[J]. Rare Metal Materials and Engineering,2021,50(11):3862~3870.]
DOI:10.12442/j. issn.1002-185X.20200680

復制
文章指標
  • 點擊次數:
  • 下載次數:
  • HTML閱讀次數:
  • 引用次數:
歷史
  • 收稿日期:2020-09-08
  • 最后修改日期:2020-11-02
  • 錄用日期:2020-11-23
  • 在線發布日期: 2021-11-25
  • 出版日期: 2021-11-24