最新色国产精品精品视频,中文字幕日韩一区二区不卡,亚洲有码转帖,夜夜躁日日躁狠狠久久av,中国凸偷窥xxxx自由视频

+高級檢索
半固態擠壓鑄造A356合金在熱處理過程中的組織和性能演化
作者:
作者單位:

1.東北大學材料科學與工程學院;2.中信戴卡集團研究院;3.天津理工大學

作者簡介:

通訊作者:

中圖分類號:

基金項目:

國家重點研發計劃（2018YFB2001800）、國家自然科學基金項目（U1764254）


Microstructure Evolution and Properties Improvement of Semi - solid Squeezed A356 Alloy during Heat Treatment
Author:
Affiliation:

1.Key Laboratory of Lightweight Structural Materials Liaoning Province,School of Materials Science and Engineering,Northeastern University;2.The CITIC Dicastal Institute

Fund Project:

National Key Research and Development Program of China (2018YFB2001800); National Natural Science Foundation of China (U1764254)

  • 摘要
    • |
  • 圖/表
    • |
  • 訪問統計
    • |
  • 參考文獻
    • |
  • 相似文獻
    • |
  • 引證文獻
    • |
  • 資源附件
    • |
  • 文章評論
    摘要:

    半固態擠壓鑄造的A356合金首先在540℃進行固溶處理,隨著固溶溫度升高M(jìn)g和Si原子逐漸溶解于基體中,并產生了固溶強化作用?？估瓘?qiáng)度、延伸率和硬度在固溶6小時達到峰值,之后合金力學性能隨固溶時間延長而下降。在固溶處理之后合金在180℃進行了不同時間的時效處理。隨著時效時間延長,Mg2Si相逐漸在基體中析出,析出相顯著球化細化,尺寸約為2μm。經過對合金組織和力學性能的分析,半固態擠壓鑄造A356合金的最佳熱處理制度為：540℃固溶6小時,180℃時效4小時。經過固溶和時效處理后的合金抗拉強度達到336MPa,延伸率達到6.9%,硬度達到HV124,相對于熱處理前提升了106.7%。

    Abstract:

    A356 alloy was processed by semi - solid squeeze casting followed by solution treatment at 540℃. With increasing solution time, Mg and Si elements dissolved into the matrix and led to solid solution strengthening. Tensile strength, elongation and hardness peaked at 6 h and then decreased during solution treatment. Aging treatment at 180℃ for different time was carried out after solution treatment. With increasing aging time, the fine spherical Mg2Si phases precipitated in the A356 alloy matrix, which were ca. 2 μm in size. The optimum heat treatment process was solid solution at 540℃ for 6 h followed by aging at 180℃ for 4 h. After solution and aging treatment, tensile strength and elongation reached 336 MPa and 6.9%, respectively. Hardness value reached 124 HV after heat treatment, which was 106.7% higher than the cast alloy.

    參考文獻
    相似文獻
    引證文獻
引用本文

鐵鏑,顏路飛,管仁國,季兆山,李洪超,王祥,劉海峰,劉德寶,陳民芳.半固態擠壓鑄造A356合金在熱處理過程中的組織和性能演化[J].稀有金屬材料與工程,2021,50(3):746~752.[Di Tie, Lufei Yan, Renguo Guan, Zhaoshan Ji, Hongchao Li, Xiang Wang, Haifeng Liu, Debao Liu, Minfang Chen. Microstructure Evolution and Properties Improvement of Semi - solid Squeezed A356 Alloy during Heat Treatment[J]. Rare Metal Materials and Engineering,2021,50(3):746~752.]
DOI：10.12442/j. issn.1002-185X.20200026

復制
文章指標
  • 點擊次數:
  • 下載次數:
  • HTML閱讀次數:
  • 引用次數:
歷史
  • 收稿日期:2020-01-12
  • 最后修改日期:2020-02-17
  • 錄用日期:2020-02-21
  • 在線發布日期: 2021-04-02
  • 出版日期: