最新色国产精品精品视频,中文字幕日韩一区二区不卡,亚洲有码转帖,夜夜躁日日躁狠狠久久av,中国凸偷窥xxxx自由视频

+高級檢索
過量的Fe2O3對鋁熱法制備微納結構316L奧氏體不銹鋼組織和拉伸性能的影響
作者:
作者單位:

蘭州理工大學

作者簡介:

通訊作者:

中圖分類號:

基金項目:

國家自然基金Grant No. 51561020


Effect of Excess Fe2O3 in Reactions on Microstructure and Tensile Properties of Micro-nano Structure 316L Austenitic Stainless Steels Prepared by Aluminothermic Method
Author:
Affiliation:

State Key Laboratory of Advanced Processing and Recycling of Nonferrous Metals,Lanzhou University of Technology

Fund Project:

  • 摘要
    • |
  • 圖/表
    • |
  • 訪問統計
    • |
  • 參考文獻
    • |
  • 相似文獻
    • |
  • 引證文獻
    • |
  • 資源附件
    • |
  • 文章評論
    摘要:

    不銹鋼結構和成分的調節對其獲得良好綜合性能至關重要。本文為了使鋁熱反應完全，降低316L ASSs中殘余Al的含量，在反應粉體中加入了不同過量比的Fe2O3粉末，詳細分析了過量Fe2O3對316L奧氏體不銹鋼微納米組織和拉伸性能的影響。結果表明，隨著Fe2O3過量百分比的增加，鐵素體相的體積分?jǐn)?shù)顯著降低，而納米晶的體積分?jǐn)?shù)由87.4%提高到了93.4%，平均晶粒尺寸由32 nm降低到了22 nm。對比分析表明，鋁熱法制備316L ASSs的最佳工藝參數為添加過量比5.0 %的Fe2O3，在該條件下制備的單相奧氏體鋼，其抗拉強度為573.92 MPa，屈服強度為340.12 MPa，延伸率約為4.68%。

    Abstract:

    The regulation of structure and composition is very important for obtaining stainless steel with good comprehensive properties. In present paper, Fe2O3 powers with different excess ratios were added in reaction powders to make aluminothermic reaction completely and reduce the content of Al in the 316L ASSs. The effects of excess Fe2O3 in reactions on microstructure and tensile properties of micro-nano structure of 316L austenitic stainless steels were analyzed in detail. The results showed that, with the increase of Fe2O3 excess percentage, the volume fraction of ferrite phase reduced significantly while the volume fraction of nanocrystalline increased from 87.4 % to 93.4 % and the average grain size decreased from 32 nm to 22 nm. The comparative analysis showed that the Fe2O3 excess percentage of 5.0 % was the best process parameter for the 316L ASSs preparation by the aluminothermic method. For the single phase austenitic steel prepared under this condition, the tensile strength was 573.92 MPa, the yield strength was 340.12 MPa, and the elongation was about 4.68 %.

    參考文獻
    相似文獻
    引證文獻
引用本文

王嬌,鄭月紅,魏瑩,喇培清,袁覓文,石玉.過量的Fe2O3對鋁熱法制備微納結構316L奧氏體不銹鋼組織和拉伸性能的影響[J].稀有金屬材料與工程,2021,50(2):443~450.[Jiao Wang, Yuehong Zheng, Ying Wei, Peiqing La, Miwen Yuan, Yu Shi. Effect of Excess Fe2O3 in Reactions on Microstructure and Tensile Properties of Micro-nano Structure 316L Austenitic Stainless Steels Prepared by Aluminothermic Method[J]. Rare Metal Materials and Engineering,2021,50(2):443~450.]
DOI：10.12442/j. issn.1002-185X.20200002

復制
文章指標
  • 點擊次數:
  • 下載次數:
  • HTML閱讀次數:
  • 引用次數:
歷史
  • 收稿日期:2020-01-02
  • 最后修改日期:2020-06-08
  • 錄用日期:2020-06-09
  • 在線發布日期: 2021-03-09
  • 出版日期: