最新色国产精品精品视频,中文字幕日韩一区二区不卡,亚洲有码转帖,夜夜躁日日躁狠狠久久av,中国凸偷窥xxxx自由视频

+高級檢索
冷軋預變形對新型鋁鋰合金的時效析出與力學性能影響
作者:
作者單位:

中南大學輕質高強結構材料國防科技重點實驗室

作者簡介:

通訊作者:

中圖分類號:

基金項目:

預研基金((6142912180105，41422060204)


Effect of cold rolling pre-deformation on microstructure andproperties of a new Aluminum lithium alloy
Author:
Affiliation:

Science and Technology on High-strength Structural Materials,Central South University

Fund Project:

  • 摘要
    • |
  • 圖/表
    • |
  • 訪問統計
    • |
  • 參考文獻
    • |
  • 相似文獻
    • |
  • 引證文獻
    • |
  • 資源附件
    • |
  • 文章評論
    摘要:

    采用大氣熔煉鑄造及熱變形方法制備了Al-4.5Cu-1Li-0.7Mg-1Zn-0.3Ag-0.3Mn-0.2Zr新型鋁鋰合金板材。通過維氏硬度、拉伸性能、掃描電鏡、透射電鏡等方法，研究了固溶后不同冷軋預變形量對顯微組織和力學性能影響。結果表明，時效前的冷軋預變形量有效促進了新型鋁鋰基體合金中T1(Al2CuLi)相的析出與均勻分布，減少了θ′(Al2Cu)相的體積分?jǐn)?shù)。冷軋預變形量的增加，縮短了峰時效時間，晶界析出相由連續析出變?yōu)榉沁B續析出，無沉淀析出區寬度變小。當冷軋預變形量為15%時，時效態合金的屈服強度與抗拉強度分別達到了668 MPa、690 MPa，延伸率保持在7.9%。

    Abstract:

    New Al-4.5Cu-1Li-0.7Mg-1Zn-0.3Ag-0.3Mn-0.2Zr aluminium lithium alloys were prepared by casting and hot formation. The effects of cold-rolled pre-deformation on microstructure and mechanical properties after solid solution were investigated using Vickers hardness, tensile testing, scanning electron microscopy and transmission electron microscopy. The results show that cold-rolled pre-deformation can effectively promote the precipitation of T1 phases and reduce the volume fraction of θ" phases in the matrix. Adding cold-rolled pre-deformation resulted in an enhanced age hardening response and shorter the time to reach peak aging. At the same time, the grain boundary precipitates change from continuous precipitation to discontinuous precipitation, and the width of the PFZs becomes smaller. The yield strength, tensile strength and elongation of as-aged alloy, when the pre-deformation amount was 15%, were 668 MPa, 690 MPa and 7.9%, respectively.

    參考文獻
    相似文獻
    引證文獻
引用本文

吳名冬,肖代紅,陳煒斌,黃靜,黃蘭萍,劉文勝.冷軋預變形對新型鋁鋰合金的時效析出與力學性能影響[J].稀有金屬材料與工程,2020,49(9):3251~3259.[Wu Mingdong, Xiao Daihong, Chen Weibing, Huang Jin, Huang Lanping, Liu Wensheng. Effect of cold rolling pre-deformation on microstructure andproperties of a new Aluminum lithium alloy[J]. Rare Metal Materials and Engineering,2020,49(9):3251~3259.]
DOI：10.12442/j. issn.1002-185X.20190782

復制
文章指標
  • 點擊次數:
  • 下載次數:
  • HTML閱讀次數:
  • 引用次數:
歷史
  • 收稿日期:2019-09-23
  • 最后修改日期:2019-10-24
  • 錄用日期:2019-11-12
  • 在線發布日期: 2020-10-15
  • 出版日期: