2超導線材時,易于出現斷芯、斷線現象。針對一問題,本實驗中以強度較高的夢乃爾合金(Monel 400)作為包套材料,以旋鍛、拉拔、軋制及中間熱處理相結合的加工手段成功的制備出直徑Φ1.0 mm、37芯結構的多芯MgB2超導長線材。微觀結構分析表明多芯線材中MgB2芯絲及替換芯絲等亞組元的分布較為規整,阻隔層未出現明顯破損現象,最終線材中MgB2超導芯絲的平均直徑約80 μm。室溫拉伸性能顯示熱處理前MgB2線材的屈服強度為759 MPa,熱處理后的線材為248 MPa。4.2 K、4 T下,線材的臨界電流密度Jc達到2.31×105 A.cm-2,工程臨界電流密度達到3.16×104 A.cm-2。"/>

最新色国产精品精品视频,中文字幕日韩一区二区不卡,亚洲有码转帖,夜夜躁日日躁狠狠久久av,中国凸偷窥xxxx自由视频

+高級檢索
原位粉末裝管法37芯MgB2線材的制備及性能研究
作者:
作者單位:

1.西北有色金屬研究院;2.西藏民族大學信息工程學院;3.西部超導材料科技股份有限公司

作者簡介:

通訊作者:

中圖分類號:

基金項目:

國家自然科學基金(51772250),陜西省自然科學基金(2017ZDJC-19)和西安市未央?yún)^(qū)科技計劃項目(201818)


Fabrication and properties of 37-filaments MgB2 superconducting wires by in-situ powder-in-tube method
Author:
Affiliation:

Fund Project:

  • 摘要
    • |
  • 圖/表
    • |
  • 訪問統計
    • |
  • 參考文獻
    • |
  • 相似文獻
    • |
  • 引證文獻
    • |
  • 資源附件
    • |
  • 文章評論
    摘要:

    傳統的Cu包套原位粉末裝管法(in situ PIT)制備多芯MgB2超導線材時,易于出現斷芯、斷線現象。針對一問題,本實驗中以強度較高的夢乃爾合金(Monel 400)作為包套材料,以旋鍛、拉拔、軋制及中間熱處理相結合的加工手段成功的制備出直徑Φ1.0 mm、37芯結構的多芯MgB2超導長線材。微觀結構分析表明多芯線材中MgB2芯絲及替換芯絲等亞組元的分布較為規整,阻隔層未出現明顯破損現象,最終線材中MgB2超導芯絲的平均直徑約80 μm。室溫拉伸性能顯示熱處理前MgB2線材的屈服強度為759 MPa,熱處理后的線材為248 MPa。4.2 K、4 T下,線材的臨界電流密度Jc達到2.31×105 A.cm-2,工程臨界電流密度達到3.16×104 A.cm-2。

    Abstract:

    The filament fractures or wire breaks in multi core MgB2 wire was appeared frequent while using the traditional in-situ powder in tube (PIT) method with Cu as the sheath material. For this problem, the 37 filament MgB2 long wires with the diameter of 1 mm, sheathed with higher strength Monel alloys (Monel 400) is fabricated with compound fabrication process including rotary swage, drawing, rolling and middle annealing heat treatment。Microstracture showed that the sub component including MgB2 filament and NbCu replacement is uniformly distributed and the Nb diffusion barrier is no breaking points. The mean diameter in MgB2 filament is only 80 μm in final wires. The yield strength is around 759 MPa. for the as-drawn wire and 248 MPa for the sintered wire. The critical current density (Jc) and engineering current density (Je) are arrived 2.31×105 A.cm-2 and 3.16×104A.cm-2 at 4.2 K、4 T respectively.

    參考文獻
    相似文獻
    引證文獻
引用本文

王慶陽,張可榮,熊曉梅,楊芳,郗丹,王大友,李成山,閆果,馮勇,張平祥.原位粉末裝管法37芯MgB2線材的制備及性能研究[J].稀有金屬材料與工程,2020,49(8):2825~2829.[WANG Qingyang, ZHANG Kerong, XIONG Xiaomei, YANG Fang, XI Dan, WANG Dayou, LI Chengshan, YAN Guo, FENG Yong, ZHANG Pingxiang. Fabrication and properties of 37-filaments MgB2 superconducting wires by in-situ powder-in-tube method[J]. Rare Metal Materials and Engineering,2020,49(8):2825~2829.]
DOI：10.12442/j. issn.1002-185X.20190619

復制
文章指標
  • 點擊次數:
  • 下載次數:
  • HTML閱讀次數:
  • 引用次數:
歷史
  • 收稿日期:2019-07-27
  • 最后修改日期:2019-10-17
  • 錄用日期:2019-10-18
  • 在線發布日期: 2020-09-27
  • 出版日期: