最新色国产精品精品视频,中文字幕日韩一区二区不卡,亚洲有码转帖,夜夜躁日日躁狠狠久久av,中国凸偷窥xxxx自由视频

+高級檢索
高氧含量Ti-15Mo合金的組織性能研究
作者:
作者單位:

沈陽航空航天大學 材料科學與工程學院

作者簡介:

通訊作者:

中圖分類號:

TG146.3

基金項目:

國家自然科學基金資助(項目號51601121)


Microstructure and Properties of Ti-15Mo Alloy with High Oxygen Content
Author:
Affiliation:

School of Materials Science and Engineering,Shenyang Aerospace University

Fund Project:

  • 摘要
  • |
  • 圖/表
  • |
  • 訪問統計
  • |
  • 參考文獻
  • |
  • 相似文獻
  • |
  • 引證文獻
  • |
  • 資源附件
  • |
  • 文章評論
    摘要:

    本文針對氧含量較高的Ti-15Mo合金,研究了該合金的鑄態組織以及通過不同溫度固溶處理得到的組織和對應的性能。成分分析表明,該合金溶入了0.8wt%的O,以下稱為Ti-15Mo-0.8O合金。利用光學顯微鏡(OM)、掃描電子顯微鏡(SEM)和X射線衍射儀(XRD)觀察分析了Ti-15Mo-0.8O合金的組織轉變。結果表明:合金的鑄態組織由α和β兩相組成;經過900℃、1000℃、1100℃/2h固溶處理后,合金的相組成轉變過程為α+β+TO→β+ TO→β;隨著固溶溫度的上升,合金β相的晶格常數逐漸增加。利用維氏硬度計和萬能試驗機進行硬度和室溫壓縮測試。結果表明:1100℃/2h固溶處理后的試樣獲得最高硬度,其值為455HV20;1100℃/2h固溶處理后的試樣具有最好的壓縮性能,壓縮屈服強度為和抗壓強度分別為1617Mpa和2308Mpa,壓縮率為22%。

    Abstract:

    In this paper, the as-cast microstructure of Ti-15Mo alloy with high oxygen content and the microstructure and corresponding properties obtained by solution treatment at different temperatures are studied. Composition analysis shows that 0.8wt% O is dissolved in the alloy, hereinafter referred to as Ti-15Mo-0.8O alloy. The microstructure transformation of Ti-15Mo-0.8O alloy was observed and analyzed by optical microscope (OM), scanning electron microscope (SEM) and X-ray diffraction (XRD). The results show that the as-cast structure of the alloy consists of α and β phases. After solid solution treatment at 900℃, 1000℃, 1100℃/2h, the phase composition transformation process of the alloy is α+β+TOβ+TOβ; The lattice constant of β phase of alloy gradually increases with the increase of solid solution temperature. Hardness and room temperature compression tests were carried out by Vickers hardness tester and universal testing machine. The results show that the highest hardness of the sample after solution treatment at 1100℃/2h is 455HV20;The sample after solution treatment at 1100℃/2h has the best compression performance, with compressive yield strength of 1617Mpa and compressive strength of 2308Mpa respectively, and compression ratio of 22%.

    參考文獻
    相似文獻
    引證文獻
引用本文

王艷晶,徐再東,徐榮正,胡秋野,施冬雨,蘆鑫.高氧含量Ti-15Mo合金的組織性能研究[J].稀有金屬材料與工程,2020,49(7):2425~2430.[WANG Yanjing, XU Zaidong, Xu Rongzheng, Hu Qiuye, Shi Dongyu, Lu Xin. Microstructure and Properties of Ti-15Mo Alloy with High Oxygen Content[J]. Rare Metal Materials and Engineering,2020,49(7):2425~2430.]
DOI:10.12442/j. issn.1002-185X.20190548

復制
文章指標
  • 點擊次數:
  • 下載次數:
  • HTML閱讀次數:
  • 引用次數:
歷史
  • 收稿日期:2019-06-28
  • 最后修改日期:2019-07-31
  • 錄用日期:2019-08-21
  • 在線發布日期: 2020-08-31
  • 出版日期: