3Ni2組成的外層,Al3Ni2內層及富Al的互擴散層,Ce、Y元素主要集中在共滲層的外層,起到細化晶粒及促滲的作用。固體粒子沖蝕結果表明：Al-Ce-Y共滲顯著的提高了DZ125合金在小攻角下的抗固體粒子沖蝕性能,沖蝕機理為犁削和切削損傷；隨著攻角的增大,Al-Ce-Y共滲層的沖蝕率逐漸增大,沖蝕機理向脆性斷裂和疲勞破壞轉變,當攻角為90度時,其沖蝕率高于DZ125基體。"/>

最新色国产精品精品视频,中文字幕日韩一区二区不卡,亚洲有码转帖,夜夜躁日日躁狠狠久久av,中国凸偷窥xxxx自由视频

+高級檢索
DZ125合金表面Ce-Y改性鋁化物滲層的組織及抗沖蝕性能
DOI:
作者:
作者單位:

北方民族大學 材料科學與工程學院,表面工程研究所 太原理工大學,北方民族大學 材料科學與工程學院,表面工程研究所 太原理工大學,北方民族大學 材料科學與工程學院,北方民族大學 材料科學與工程學院

作者簡介:

通訊作者:

中圖分類號:

基金項目:

寧夏自然科學基金重點項目(NZ16083)


Microstructure and Solid Particle Erosion Behavior of Ce-Y jointly modified Aluminide Coatings Prepared on DZ125 alloy by Pack Cementation Process
Author:
Affiliation:

School of material science engineering,Beifang University of Nationalities,,School of material science engineering,Beifang University of Nationalities,,School of material science engineering,Beifang University of Nationalities,School of material science engineering,Beifang University of Nationalities

Fund Project:

  • 摘要
    • |
  • 圖/表
    • |
  • 訪問統計
    • |
  • 參考文獻
    • |
  • 相似文獻
    • |
  • 引證文獻
    • |
  • 資源附件
    • |
  • 文章評論
    摘要:

    通過擴散滲法在DZ125合金表面制備了Ce-Y聯合改性鋁化物滲層,分析了共滲層的結構及相組成,并對其組織形成機理和抗沖蝕性能進行了研究。結果表明：1000℃/2h下所制備的Al-Ce-Y共滲層具有多層結構,由外向內依次為NiAl和少量Al3Ni2組成的外層,Al3Ni2內層及富Al的互擴散層,Ce、Y元素主要集中在共滲層的外層,起到細化晶粒及促滲的作用。固體粒子沖蝕結果表明：Al-Ce-Y共滲顯著的提高了DZ125合金在小攻角下的抗固體粒子沖蝕性能,沖蝕機理為犁削和切削損傷；隨著攻角的增大,Al-Ce-Y共滲層的沖蝕率逐漸增大,沖蝕機理向脆性斷裂和疲勞破壞轉變,當攻角為90度時,其沖蝕率高于DZ125基體。

    Abstract:

    Al and Y modified aluminide coatings were prepared by pack cementation process at 1000℃ for 2 h. The microstructure and constituent phases of the co-deposition coatings were studied, the formative mechanism and erosion behavior of the coating were also analysed. The results show that the coating prepared by co-depositing Al-Ce-Y at 1000℃ for 2 h have a multiple layer structure: an outer layer composed of NiAl and a little Al3Ni2 , a middle layer composed of Al3Ni2 and a Al-rich inter-diffusion zone. Y and Ce mainly existed in the outer layer, which plays the role of reducing the grain size and promoting permeation. The solid particle erosion resistance of DZ125 alloy with Al-Ce-Y coating was significantly increased at the small impact angle, and then the erosion rate of Al-Ce-Y coatings increased with the increasing of impact angles, and the erosion mechanism shift from plough and cutting damage to brittle fracture and fatigue failure. The erosion rate of Al-Ce-Y coating is higher than that of DZ125 matrix when the impact angle at 90°.

    參考文獻
    相似文獻
    引證文獻
引用本文

李涌泉,唐賓,耿桂宏,林乃明,侯俊峰,秦春. DZ125合金表面Ce-Y改性鋁化物滲層的組織及抗沖蝕性能[J].稀有金屬材料與工程,2017,46(11):3388~3393.[Li Yongquan, Tang Bin, Geng Guihong, Lin Naiming, Hou Junfeng, Qin Chun. Microstructure and Solid Particle Erosion Behavior of Ce-Y jointly modified Aluminide Coatings Prepared on DZ125 alloy by Pack Cementation Process[J]. Rare Metal Materials and Engineering,2017,46(11):3388~3393.]
DOI：[doi]

復制
文章指標
  • 點擊次數:
  • 下載次數:
  • HTML閱讀次數:
  • 引用次數:
歷史
  • 收稿日期:2016-09-09
  • 最后修改日期:2016-11-18
  • 錄用日期:2016-12-07
  • 在線發布日期: 2017-12-13
  • 出版日期: