最新色国产精品精品视频,中文字幕日韩一区二区不卡,亚洲有码转帖,夜夜躁日日躁狠狠久久av,中国凸偷窥xxxx自由视频

+高級檢索
連接溫度對高鈮TiAl合金擴散接頭組織和強度的影響
DOI:
作者:
作者單位:

哈爾濱工業大學 先進焊接與連接國家重點實驗室,哈爾濱工業大學 先進焊接與連接國家重點實驗室

作者簡介:

通訊作者:

中圖分類號:

TG454

基金項目:

國家科技重大專項資助，國家自然科學基金項目（面上項目，重點項目，重大項目），上海航天科技創新基金


Effect of Bonding Temperature on Microstructure and Strength of High Nb Containing TiAl Alloy Diffusion Joints
Author:
Affiliation:

Harbin Institute of Technology,State Key Laboratory of Advanced Welding and Joining,Harbin Institute of Technology,State Key Laboratory of Advanced Welding and Joining

Fund Project:

National Science and technology major special fund, National Natural Science Foundation of China(general project, Key project, Major project), Shanghai Aerospace Science and Technology Innovation Fund

  • 摘要
    • |
  • 圖/表
    • |
  • 訪問統計
    • |
  • 參考文獻
    • |
  • 相似文獻
    • |
  • 引證文獻
    • |
  • 資源附件
    • |
  • 文章評論
    摘要:

    摘 要: 在連接工藝參數為1000℃～1200℃/25MPa/90min情況下，對高鈮TiAl合金（TAN）進行直接擴散連接。采用SEM、EDS、XRD和EBSD等方法對連接界面微觀組織進行分析，并研究了連接溫度對接頭界面結構和剪切強度的影響。結果表明：當連接溫度T<1100℃時，連接界面清晰垂直，繼續升高溫度，界面消失；擴散連接過程中，連接界面處出現再結晶現象，隨著連接溫度的升高，再結晶晶粒不斷增多并長大，并且再結晶區域出現大量α2相；當連接溫度達到1150℃時，接頭平均抗剪強度達到最大值為105MPa。

    Abstract:

    Abstract: Direct diffusion bonding of high Nb containing TiAl alloy(TAN) has been conducted at temperatures of 1000℃～1200℃ for 90min under 25MPa in vacuum. The effect of bonding temperature on interfacial microstructure and mechanical properities of joints was studied and the microstructure of joints was detected by using SEM, EDS, XRD and EBSD. The results indicate that the distinct interface can be seen when the temperature is below 1100℃ and the higher temperature promotes interface disappear; recrystallized grains are observed at bonding interface. The number and size of grains increase with the rise of temperature and a lot of α2 phase appears in the area of recrystallization; the highest average shear strength of 105 MPa was achieved when bonded at the temperature of 1150℃ for 90min under 25MPa.

    參考文獻
    相似文獻
    引證文獻
引用本文

包潘飛,宋曉國.連接溫度對高鈮TiAl合金擴散接頭組織和強度的影響[J].稀有金屬材料與工程,2018,47(7):2132~2136.[Bao Panfei, Song Xiaoguo. Effect of Bonding Temperature on Microstructure and Strength of High Nb Containing TiAl Alloy Diffusion Joints[J]. Rare Metal Materials and Engineering,2018,47(7):2132~2136.]
DOI：[doi]

復制
文章指標
  • 點擊次數:
  • 下載次數:
  • HTML閱讀次數:
  • 引用次數:
歷史
  • 收稿日期:2016-07-04
  • 最后修改日期:2016-08-25
  • 錄用日期:2016-09-18
  • 在線發布日期: 2018-10-10
  • 出版日期: