最新色国产精品精品视频,中文字幕日韩一区二区不卡,亚洲有码转帖,夜夜躁日日躁狠狠久久av,中国凸偷窥xxxx自由视频

+高級檢索
Ti3AlC2顆粒含量對Ti3AlC2/ZA27 復合材料性能的影響
DOI:
作者:
作者單位:

北京交通大學,北京交通大學,北京交通大學,北京交通大學,北京交通大學,北京交通大學

作者簡介:

通訊作者:

中圖分類號:

基金項目:

中央高?；究蒲袠I(yè)務費


Effect of Ti3AlC2 content on mechanical properties of Ti3AlC2/ZA27 composites
Author:
Affiliation:

School of Mechanical Electronic Control Engineering,Beijing Jiaotong University,School of Mechanical Electronic Control Engineering,Beijing Jiaotong University,School of Mechanical Electronic Control Engineering,Beijing Jiaotong University,School of Mechanical Electronic Control Engineering,Beijing Jiaotong University,School of Mechanical Electronic Control Engineering,Beijing Jiaotong University,School of Mechanical Electronic Control Engineering,Beijing Jiaotong University

Fund Project:

  • 摘要
    • |
  • 圖/表
    • |
  • 訪問統計
    • |
  • 參考文獻
    • |
  • 相似文獻
    • |
  • 引證文獻
    • |
  • 資源附件
    • |
  • 文章評論
    摘要:

    通過無壓燒結技術和機械合金化技術，在燒結溫度為870 °C，保溫時間為2.5h的工藝條件下，制備了四種不同體積含量的Ti3AlC2 顆粒含量的Ti3AlC2/ZA27復合材料。研究了Ti3AlC2 顆粒含量對Ti3AlC2 /ZA27復合材料的硬度，密度，拉伸強度和彎曲強度的影響。結果表明界面處的微弱的化學反應有助于提高復合材料的界面結合能力，進而提高Ti3AlC2 /ZA27復合材料的機械性能。此外，隨著Ti3AlC2 顆粒含量增多，Ti3AlC2 /ZA27復合材料的硬度和力學強度都隨之增大，這主要歸因于納米尺度的Ti3AlC2顆粒的彌散增強結果。然而，隨著Ti3AlC2 顆粒的增加到40 vol. %, 由于孔隙的增多，Ti3AlC2 /ZA27復合材料的硬度和力學強度又出現下降。對比制得的四種Ti3AlC2 /ZA27復合材料，30Ti3AlC2/ZA27復合材料擁有最大的抗拉強度、抗彎曲強度以及維氏硬度，分別為310 MPa，528 MPa 和1.24 GPa. 這些優異的性能除了歸因于良好的界面結合，還歸因于Ti3AlC2顆粒的細晶強化和彌散強化作用。

    Abstract:

    ZA27 alloy-based composites reinforced by 10–40 vol. % Ti3AlC2 particles in a step of 10 vol. % were prepared by pressurelessly sintering mechanical alloyed powders at 870 °C for 2.5 h. The effects of Ti3AlC2 content on hardness, density, stretching and bending performance were studied. The results demonstrate that a well bonded interface could be obtained by weak reaction occurred at the interface between Ti3AlC2 and ZA27 alloy during sintering process, and which is beneficial to the mechanical properties of the Ti3AlC2 /ZA27 composites. An increase in Ti3AlC2 content (up to 30 vol. %) leads to enhanced hardness and mechanical strength of the composites due to dispersion strengthening of nano-sized Ti3AlC2 particle. However, with an increase in Ti3AlC2 content to 40 vol. %, the hardness and strength decrease because of the growing number of pores. Comparing the four composites with different Ti3AlC2 contents, the 30Ti3AlC2 /ZA27 composite possesses the best properties of 310 MPa for tensile strength, 528 MPa for bending strength and 1.24 GPa for Vickers hardness. Besides the good interfacial bonding, the improved mechanical properties of the Ti3AlC2 /ZA27 composites are also attributed to the fine-grained microstructure and well dispersed reinforcements.

    參考文獻
    相似文獻
    引證文獻
引用本文

李海燕,周洋,崔傲,李世波,黃振鶯,翟洪祥. Ti3AlC2顆粒含量對Ti3AlC2/ZA27 復合材料性能的影響[J].稀有金屬材料與工程,2018,47(4):1069~1074.[Hai-Yan Li, Yang Zhou, Ao Cui, Shi-Bo Li, Zhen-Ying Huang, Hong-Xiang Zhai. Effect of Ti3AlC2 content on mechanical properties of Ti3AlC2/ZA27 composites[J]. Rare Metal Materials and Engineering,2018,47(4):1069~1074.]
DOI：[doi]

復制
文章指標
  • 點擊次數:
  • 下載次數:
  • HTML閱讀次數:
  • 引用次數:
歷史
  • 收稿日期:2016-05-11
  • 最后修改日期:2016-09-16
  • 錄用日期:2016-10-18
  • 在線發布日期: 2018-05-31
  • 出版日期: