基面織構組分不斷降低，而包含<11 3>方向的錐面織構組分呈現出先增加后減小的趨勢，導致合金的延伸率和杯突值先增加后減小。當鈣含量為0.5%時，合金表現出最強的橫向分裂織構特征，綜合力學性能最優，最大強度為238MPa、最大延伸率為22%、杯突值為4.31mm。"/>

最新色国产精品精品视频,中文字幕日韩一区二区不卡,亚洲有码转帖,夜夜躁日日躁狠狠久久av,中国凸偷窥xxxx自由视频

+高級檢索
鈣元素含量對Mg-2Al-xCa-0.2Gd鎂合金織構演變和性能的影響
DOI:
作者:
作者單位:

北京科技大學冶金工程研究院,北京科技大學冶金工程研究院,北京科技大學冶金工程研究院,北京科技大學冶金工程研究院,北京科技大學冶金工程研究院

作者簡介:

通訊作者:

中圖分類號:

TG 164.2

基金項目:

中央高?；緲I(yè)務費（FRF-IC-15-002）


The Influence of Calcium (Ca) Content on the Texture Evolution and Mechanical Properties of Mg-2Al-xCa-0.2Gd Magnesium Alloys
Author:
Affiliation:

Engineering Research Institute,University of Science and Technology Beijing,Engineering Research Institute,University of Science and Technology Beijing,Engineering Research Institute,University of Science and Technology Beijing,Engineering Research Institute,University of Science and Technology Beijing,

Fund Project:

National Natural Science Foundation of China (51202175)

  • 摘要
    • |
  • 圖/表
    • |
  • 訪問統計
    • |
  • 參考文獻
    • |
  • 相似文獻
    • |
  • 引證文獻
    • |
  • 資源附件
    • |
  • 文章評論
    摘要:

    在鎂合金中加入適量鈣元素，具有細化晶粒、提高強度和耐熱性能等優點。本文通過OM、SEM、EBSD、XRD等分析手段，研究了不同鈣含量對Mg-2Al-xCa-0.2Gd (x=0.2, 0.5, 1.0, 2.0; mass%)合金晶粒尺寸、織構和力學性能的影響。研究結果表明：隨著鈣含量的不斷增多，合金晶粒尺寸不斷減小，強度不斷增加。但織構具有不同的演化規律，{0001}<11 0>基面織構組分不斷降低，而包含<11 3>方向的錐面織構組分呈現出先增加后減小的趨勢，導致合金的延伸率和杯突值先增加后減小。當鈣含量為0.5%時，合金表現出最強的橫向分裂織構特征，綜合力學性能最優，最大強度為238MPa、最大延伸率為22%、杯突值為4.31mm。

    Abstract:

    The addition of proper amount of calcium to magnesium alloys can refine grain size, enhance strength and heat-resistant. The influence of different contents of calcium (Ca) on the grain size, texture and mechanical properties of Mg-2Al-xCa-0.2Gd (x=0.2, 0.5, 1.0, 2.0; mass%) were investigated in this paper through the OM, SEM，EBSD and XRD techniques. The results showed that with the increase of the Ca content the grain size gradually decreased which leads to the improvement of strength. However, the texture evolution had different characterization such as the decrease of {0001}<11 0> texture, the firstly increase and then decrease of the pyramidal texture components containing the <11 3> direction, which resulted in the corresponding change of elongation and Erichsen value. The magnesium alloy with 0.5% calcium content exhibited bimodal texture characterization and showed the best mechanical properties with the maximal tensile strength of 238MPa, the total elongation of 22% and the Erichsen value of 4.31mm.

    參考文獻
    相似文獻
    引證文獻
引用本文

江海濤,劉鵬,康強,董鵬,張韻.鈣元素含量對Mg-2Al-xCa-0.2Gd鎂合金織構演變和性能的影響[J].稀有金屬材料與工程,2017,46(12):3897~3902.[Jiang Haitao, Liu Peng, Kang Qiang, Dong Peng, Zhangyun. The Influence of Calcium (Ca) Content on the Texture Evolution and Mechanical Properties of Mg-2Al-xCa-0.2Gd Magnesium Alloys[J]. Rare Metal Materials and Engineering,2017,46(12):3897~3902.]
DOI：[doi]

復制
文章指標
  • 點擊次數:
  • 下載次數:
  • HTML閱讀次數:
  • 引用次數:
歷史
  • 收稿日期:2015-10-28
  • 最后修改日期:2016-01-31
  • 錄用日期:2016-02-24
  • 在線發布日期: 2018-01-04
  • 出版日期: