最新色国产精品精品视频,中文字幕日韩一区二区不卡,亚洲有码转帖,夜夜躁日日躁狠狠久久av,中国凸偷窥xxxx自由视频

+高級檢索
溫度對銅膜中間層W/CuCrZr熱等靜壓焊接質量的影響
DOI:
作者:
作者單位:

核工業西南物理研究,核工業西南物理研究,核工業西南物理研究,核工業西南物理研究,核工業西南物理研究

作者簡介:

通訊作者:

中圖分類號:

基金項目:

國際熱核聚變實驗堆(ITER)計劃專項(2011GB110004),國家青年(11305055),四川省科技廳國際合作項目(2013HH0044)


Effects of hot isostatic pressing joining temperature on copper coating as the interlayer Yang Fa-Zhan Shen Li-Ru Jin Fa-Ya
Author:
Affiliation:

Southwestern insititute of physics,,,,

Fund Project:

  • 摘要
    • |
  • 圖/表
    • |
  • 訪問統計
    • |
  • 參考文獻
    • |
  • 相似文獻
    • |
  • 引證文獻
    • |
  • 資源附件
    • |
  • 文章評論
    摘要:

    采用磁控濺射沉積40μm銅膜作為中間層，分別在950℃、980℃和1050℃下通過熱等靜壓（HIP）焊接技術制備了國際熱核聚變實驗堆（ITER）計劃W/CuCrZr偏濾器部件焊接模塊，以考察溫度對磁控濺射沉積40μm銅膜作為中間層W/CuCrZr偏濾器部件焊接質量的影響。通過掃描電子顯微鏡（SEM）和X射線能譜（EDS）分析焊接界面的形貌和成分，利用超聲波無損探傷（NDT）儀對焊接界面缺陷進行了檢測，利用力學拉伸試驗機考察了焊接界面的結合強度和CuCrZr合金的力學性能。結果表明：磁控濺射法沉積40μm銅膜作為中間層，可以有效的提高HIP焊接界面質量。特別是在980℃時，所制備的焊接模塊能夠滿足ITER計劃對于偏濾器部件連接性能的要求。

    Abstract:

    The nternational thermonuclear experimental reactor (ITER) project W-Cu divertor component model was made by hot isostatic pressing (HIP) diffusion welding method under three HIP diffusion welding processes with the temperature of 950℃, 980℃ and 1050℃ respectively，and the model is studied by analyzing a module using the magnetron sputtering method to deposit a 40μm-thick copper coating as the interlayer. This paper aims to study effect of the magnetron sputtering method to deposit a 40μm-thick copper coating as the interlayer of W-Cu divertor component model properties. The morphology and composition of the tungsten and Cu-Cr-Zr alloy joints investigated by SEM and EDS, the joint defects were detected by ultrasonic non-destructive testing(NDT) equipment, the bond strength of joints were mearsured by mechanical tensile tester. The results show that magnetron sputtering method to deposit a 40μm-thick copper coating as the interlayer,it can significantly help to improve properties of Hot Isostatic Pressing Joining. Especially at 980 ℃, the welding module is fully prepared to meet the requirements of the ITER divertor.

    參考文獻
    相似文獻
    引證文獻
引用本文

楊發展,沈麗如,金凡亞,許澤金,董玉英.溫度對銅膜中間層W/CuCrZr熱等靜壓焊接質量的影響[J].稀有金屬材料與工程,2017,46(12):3972~3976.[YANG Fa-zhan, SHEN Liru, JIN Fanya, XU Zejin, DONG Yuying. Effects of hot isostatic pressing joining temperature on copper coating as the interlayer Yang Fa-Zhan Shen Li-Ru Jin Fa-Ya[J]. Rare Metal Materials and Engineering,2017,46(12):3972~3976.]
DOI：[doi]

復制
文章指標
  • 點擊次數:
  • 下載次數:
  • HTML閱讀次數:
  • 引用次數:
歷史
  • 收稿日期:2015-10-26
  • 最后修改日期:2015-12-18
  • 錄用日期:2016-01-14
  • 在線發布日期: 2018-01-04
  • 出版日期: