2Cu),且兩種厚度板材中析出相分?jǐn)?shù)和尺寸均相當,但10 mm厚熱軋板材T8峰時效抗拉強度比2 mm厚冷軋薄板高50~70 MPa左右。力學性能的差異主要來源于固溶處理后變形織構分?jǐn)?shù)的不同；經固溶處理后10 mm厚熱軋板材變形織構體積分?jǐn)?shù)遠高于2 mm冷軋薄板。"/>

最新色国产精品精品视频,中文字幕日韩一区二区不卡,亚洲有码转帖,夜夜躁日日躁狠狠久久av,中国凸偷窥xxxx自由视频

+高級檢索
一種新型超高強鋁鋰合金板材的組織與力學性能
DOI:
作者:
作者單位:

中南大學材料科學與工程學院,航天材料及工藝研究所,航天材料及工藝研究所,中南大學材料科學與工程學院,中南大學材料科學與工程學院,西南鋁業集團有限責任公司,西南鋁業集團有限責任公司

作者簡介:

通訊作者:

中圖分類號:

基金項目:

863項目(項目號2013AA032401),中南大學教師基金(項目號2013JSJJ 001)


Structures and Mechanical properties of a super-high strength Al-Li alloy
Author:
Affiliation:

School of Materials Science and Engineering,Central South University,,,School of Materials Science and Engineering,Central South University,School of Materials Science and Engineering,Central South University,Southwest Aluminum Group Co Ltd,Southwest Aluminum Group Co Ltd

Fund Project:

  • 摘要
    • |
  • 圖/表
    • |
  • 訪問統計
    • |
  • 參考文獻
    • |
  • 相似文獻
    • |
  • 引證文獻
    • |
  • 資源附件
    • |
  • 文章評論
    摘要:

    研究了課題組開發的一種新型超高強鋁鋰合金的組織與力學性能。結果表明：該合金具有優異的常規力學性能,典型T8熱處理時抗拉強度600 MPa以上,延伸率超過10%。10 mm厚熱軋板材及2 mm厚冷軋薄板T8峰時效(150oC)時析出強化相相均為T(mén)1相(Al2CuLi)與q￠相(Al2Cu),且兩種厚度板材中析出相分?jǐn)?shù)和尺寸均相當,但10 mm厚熱軋板材T8峰時效抗拉強度比2 mm厚冷軋薄板高50~70 MPa左右。力學性能的差異主要來源于固溶處理后變形織構分?jǐn)?shù)的不同；經固溶處理后10 mm厚熱軋板材變形織構體積分?jǐn)?shù)遠高于2 mm冷軋薄板。

    Abstract:

    The structures and mechanical properties of a new super-high strength Al-Li alloy developed by this group were investigated. The alloy possessed excellent properties, of which the tensile strength was greater than 600 MPa, and the elongation higher than 10%. After T8 aging, the strengthening precipitates in both cold-rolled sheet with 2 mm thickness and hot-rolled plate with 10 mm thickness were T1(Al2CuLi) and q￠(Al2Cu), and their fraction and size were basically same in the two plates with different thickness. The strength of T8-aged plate with 10 mm thickness was 50~70 MPa higher than that the T8-aged sheet with 2 mm thickness. This strength enhancement was originated from the texture fraction after solution treatment. The volume fraction of the deformation texture in the solutionized hot-rolled plate with 10 mm thickness was much higher.

    參考文獻
    相似文獻
    引證文獻
引用本文

李勁風,陳永來,張緒虎,劉晴,鄭子樵,姚勇,王劍.一種新型超高強鋁鋰合金板材的組織與力學性能[J].稀有金屬材料與工程,2017,46(12):3715~3720.[Li Jin-feng, Chen Yong-lai, Zhang Xu-hu, Liu Qing, Zheng Zi-qiao, Yao Yong, Wang Jian. Structures and Mechanical properties of a super-high strength Al-Li alloy[J]. Rare Metal Materials and Engineering,2017,46(12):3715~3720.]
DOI：[doi]

復制
文章指標
  • 點擊次數:
  • 下載次數:
  • HTML閱讀次數:
  • 引用次數:
歷史
  • 收稿日期:2015-09-28
  • 最后修改日期:2015-11-12
  • 錄用日期:2015-12-08
  • 在線發布日期: 2018-01-04
  • 出版日期: