最新色国产精品精品视频,中文字幕日韩一区二区不卡,亚洲有码转帖,夜夜躁日日躁狠狠久久av,中国凸偷窥xxxx自由视频

+高級檢索
熱處理工藝對鋯-鈦-鋼爆炸復合板粘結性能影響
DOI:
作者:
作者單位:

南京工業大學,南京工業大學,南京市鍋爐壓力容器檢驗研究院,南京工業大學,南京工業大學

作者簡介:

通訊作者:

中圖分類號:

基金項目:

國家自然科學基金(51475223)；國家質量監督檢驗檢疫總局科技計劃項目（2015QK265）；江蘇省博士后基金 (1401160C)；南京市質監局科技項目 (KJ2014011)；南京市質監局科技項目 (KJ2014012)


Effect of Heat Treatment on Bonding Property of Explosive-welded Zirconium-Titanium-steel Clad Plate
Author:
Affiliation:

Nanjing Tech University,Nanjing Tech University,Nanjing Boiler and Pressure Vessel Inspection Institute,Nanjing Tech University,Nanjing Tech University

Fund Project:

  • 摘要
    • |
  • 圖/表
    • |
  • 訪問統計
    • |
  • 參考文獻
    • |
  • 相似文獻
    • |
  • 引證文獻
    • |
  • 資源附件
    • |
  • 文章評論
    摘要:

    為得到鋯-鈦-鋼爆炸復合板最優熱處理工藝，本文采用正交試驗法研究保溫溫度、保溫時間和熱處理升降溫速率三個因素對復合板粘結強度和殘余應力的影響。結果表明，保溫溫度540℃、保溫時間1h、熱處理升降溫速率60℃/h為最優熱處理工藝，復合板可以獲得最佳粘結強度和殘余應力狀態組合，保溫溫度過高，時間太長都會降低粘結強度。此外，本文還對最優熱處理工藝下復合板結合面進行了顯微硬度測定，微觀組織和斷口形貌的觀察。分析顯示，復合板結合界面附近形成細晶區，顯微硬度較大；結合面粘結試驗斷裂形式為韌性加解理混合型斷裂。

    Abstract:

    In order to obtain the optimal heat treatment condition of explosive-welded zirconium-titanium-steel clad plate, the effects of holding temperature, holding time and rate of temperature on bonding strength and residual stress of clad plate were studied by orthogonal test method. The investigation results show that the clad plate can obtain the best combination of bonding strength and residual stress under holding temperature of 540℃, holding time of 1h and rate of temperature of 60℃/h. If the holding temperature is too higher or the holding time is too longer, the bonding strength of explosive-welded zirconium-titanium-steel clad plate will decrease. Besides, the microhardness, the microstructures and the fracture morphology of bonding interface were measured and observed under the optimal heat treatment condition. The analysis shows that the fine grain zone is formed near the bonding interface and its microhardness is higher. The fracture appearance of bonding test is a mixture of ductile and cleavage fracture.

    參考文獻
    相似文獻
    引證文獻
引用本文

邱偉光,張伯君,業成,周彬彬,周昌玉.熱處理工藝對鋯-鈦-鋼爆炸復合板粘結性能影響[J].稀有金屬材料與工程,2017,46(11):3451~3457.[Qiu Weiguang, Zhang Bojun, Ye Cheng, Zhou Binbin, Zhou Changyu. Effect of Heat Treatment on Bonding Property of Explosive-welded Zirconium-Titanium-steel Clad Plate[J]. Rare Metal Materials and Engineering,2017,46(11):3451~3457.]
DOI：[doi]

復制
文章指標
  • 點擊次數:
  • 下載次數:
  • HTML閱讀次數:
  • 引用次數:
歷史
  • 收稿日期:2015-08-18
  • 最后修改日期:2015-10-14
  • 錄用日期:2015-11-18
  • 在線發布日期: 2017-12-13
  • 出版日期: