最新色国产精品精品视频,中文字幕日韩一区二区不卡,亚洲有码转帖,夜夜躁日日躁狠狠久久av,中国凸偷窥xxxx自由视频

+高級檢索
放電等離子燒結制備B4C/CeB6復合材料
DOI:
作者:
作者單位:

北京理工大學 沖擊環境材料技術重點實驗室,北京理工大學 沖擊環境材料技術重點實驗室,北京理工大學 沖擊環境材料技術重點實驗室,北京理工大學 沖擊環境材料技術重點實驗室,首都航天機械公司

作者簡介:

通訊作者:

中圖分類號:

TB332

基金項目:

總裝預研基金


B4C/CeB6 Composite Ceramic Prepared by Spark Plasma Sintering Technology
Author:
Affiliation:

National Key Laboratory of Science and Technology on Materials Under Shock and Impact, Beijing Institute of Technology,,National Key Laboratory of Science and Technology on Materials Under Shock and Impact, Beijing Institute of Technology,,National Key Laboratory of Science and Technology on Materials Under Shock and Impact, Beijing Institute of Technology,,National Key Laboratory of Science and Technology on Materials Under Shock and Impact, Beijing Institute of Technology,,Capital Aerospace Machinery Company

Fund Project:

  • 摘要
    • |
  • 圖/表
    • |
  • 訪問統計
    • |
  • 參考文獻
    • |
  • 相似文獻
    • |
  • 引證文獻
    • |
  • 資源附件
    • |
  • 文章評論
    摘要:

    以稀土氧化物CeO2為燒結助劑，采用放電等離子(SPS)燒結工藝制備了B4C基復相陶瓷。研究了CeO2添加量對B4C基體的致密化和燒結體硬度的影響，并與純B4C樣品進行對比。借助X射線衍射和掃描電鏡分析了復合材料的物相組成和微觀結構。結果表明，CeO2粉體的添加可以顯著提高SPS條件下碳化硼的燒結性能。生成相CeB6填充在B4C晶粒之間，提高了制品的相對密度。CeO2的添加量分別為1 wt.%、2 wt.%、4 wt.%、6 wt.%、8 wt.%，當添加量為4 wt.%時，在/35MPa下，樣品的相對密度最高(96.7%)，其洛氏硬度可達到89.6HRA.

    Abstract:

    Dense B4C matrix composites were synthesized by spark plasma sintering (SPS) process using CeO2 powders as the sintering aid. The effects of CeO2 on densification and properties of B4C were studied, and compared those with sample without additive. X-ray diffraction and transmission electron microscopy was employed to examine the phase and microstructure of the composites respectively. The results indicate that the addition of CeO2 powder can significantly improve the sintering propertyof B4C. The relative density of samples increased because of the existence of generated CeB6 between B4C grains. CeO2 content ranged from 1 wt.% to 8 wt.%. The specimen with 4 wt.% CeO2 sintered at 1750℃under a pressure of 35 MPa exhibited relative density of 96.7% and Rockwell hardness of 90.7HRA. Key words: boron carbide; cerium hexaboride; ceriumoxide; SPS; densification

    參考文獻
    相似文獻
    引證文獻
引用本文

孫川,李云凱,王云飛,郭建斌,姜全振.放電等離子燒結制備B4C/CeB6復合材料[J].稀有金屬材料與工程,2016,45(8):2071~2074.[Sun Chuan, Li Yunkai, Wang Yunfei, Guo Jianbin, Jiang Quanzhen. B4C/CeB6 Composite Ceramic Prepared by Spark Plasma Sintering Technology[J]. Rare Metal Materials and Engineering,2016,45(8):2071~2074.]
DOI：[doi]

復制
文章指標
  • 點擊次數:
  • 下載次數:
  • HTML閱讀次數:
  • 引用次數:
歷史
  • 收稿日期:2014-07-09
  • 最后修改日期:2014-10-09
  • 錄用日期:2014-11-20
  • 在線發布日期: 2016-10-09
  • 出版日期: