最新色国产精品精品视频,中文字幕日韩一区二区不卡,亚洲有码转帖,夜夜躁日日躁狠狠久久av,中国凸偷窥xxxx自由视频

+高級檢索
Fe50-x/2Al50-x/2Crx體系摻雜鎢精礦粉激光燒結合金組織及性能研究
DOI:
作者:
作者單位:

遼寧工程技術大學材料科學與工程學院,遼寧工程技術大學

作者簡介:

通訊作者:

中圖分類號:

TG156.99

基金項目:

遼寧省自然科學基金項目（No.：２０１４０２０１５５）國家自然科學基金（No.：51274116）;


Study on Microstructure and Properties of Fe50-x/2Al50-x/2Crx with Addition Tungsten Concentrate Powders by Laser Sintering
Author:
Affiliation:

Liaoning technical university,Liaoning technical university

Fund Project:

  • 摘要
    • |
  • 圖/表
    • |
  • 訪問統計
    • |
  • 參考文獻
    • |
  • 相似文獻
    • |
  • 引證文獻
    • |
  • 資源附件
    • |
  • 文章評論
    摘要:

    以Fe50-x/2Al50-x/2Crx（x=4,8,12,16）體系粉末為基體，摻雜1wt%的鎢精礦粉末，壓制成坯。利用激光引燃自蔓延燒結制備原位自生顆粒增強復合材料。采用OLYMPUS4000、XRD等微觀組織結構表征手段及合金硬度、磨損性能等宏觀力學性能及腐蝕性能測試方法，研究不同Cr粉含量對燒結合金組織及性能的影響。結果表明：燒結合金物相主要為Fe3Al，Al2O3，AlCrFe2，Cr2O3及硬質顆粒相W。當Cr含量為8%時，燒結合金內部針狀組織細小致密，物相有較好的分散性；磨損率相對較低，為0.38 mg/mm2。當Cr含量為12%時，燒結合金硬度最高，為1145HV；自腐蝕電位最大，為327.643mV；腐蝕電流密度最小，為1.044mA?cm-2，腐蝕速率最低。

    Abstract:

    In situ tungsten particle reinforced Fe-Al-Cr composites were synthesized by laser induced sintering using Fe50-x/2Al50-x/2Crx (x=4, 8, 12, 16) 1wt% pct W powders. The microstructure and properties of the synthesized alloy with various Cr content were studied. By means of the observation of OLYMPUS4000, XRD, hardness test, abrasion test and corrosion resistance, studied the different Cr content for sintered alloy organization and the influence of the properties.The results showed that the sintered alloys were mainly consisted of Fe3Al, Al2O3, AlCrFe2, Cr2O3 and W phases. The needle-like microstructure is fine and good dispersed, while the abrasion rate is the lowest, about 0.38mg?mm-2, when Cr content is 8%. The hardness and correction resistance of the alloy is the best, when the content of Cr is 12%. The value of hardness, corrosion potential and passivation current density is 1145HV, 327.643mV and 1.044mA?cm-2, respectively.

    參考文獻
    相似文獻
    引證文獻
引用本文

李剛,韓鳳. Fe50-x/2Al50-x/2Crx體系摻雜鎢精礦粉激光燒結合金組織及性能研究[J].稀有金屬材料與工程,2016,45(6):1505~1508.[Li Gang, Han Feng. Study on Microstructure and Properties of Fe50-x/2Al50-x/2Crx with Addition Tungsten Concentrate Powders by Laser Sintering[J]. Rare Metal Materials and Engineering,2016,45(6):1505~1508.]
DOI：[doi]

復制
文章指標
  • 點擊次數:
  • 下載次數:
  • HTML閱讀次數:
  • 引用次數:
歷史
  • 收稿日期:2014-05-19
  • 最后修改日期:2014-09-17
  • 錄用日期:2014-10-30
  • 在線發布日期: 2016-10-08
  • 出版日期: