最新色国产精品精品视频,中文字幕日韩一区二区不卡,亚洲有码转帖,夜夜躁日日躁狠狠久久av,中国凸偷窥xxxx自由视频

+高級檢索
鑄態阻燃鈦合金的熱加工圖與變形機制研究
DOI:
作者:
作者單位:

作者簡介:

通訊作者:

中圖分類號:

基金項目:


Hot Processing Map and Deformation Mechanism of as-Cast Burn Resistant Titanium Alloy
Author:
Affiliation:

Fund Project:

  • 摘要
    • |
  • 圖/表
    • |
  • 訪問統計
    • |
  • 參考文獻
    • |
  • 相似文獻
    • |
  • 引證文獻
    • |
  • 資源附件
    • |
  • 文章評論
    摘要:

    在熱模擬試驗機上對鑄態組織的阻燃鈦合金（Ti-35V-15Cr-Si-C）進行了等溫恒應變速率熱壓縮試驗，溫度范圍為900~1200 ℃，應變速率范圍為10-3~1 s-1，測試了其真應力-真應變曲線并對曲線上的應力σ突降進行了解釋?；趧討B(tài)材料模型建立了合金的熱加工圖，結合微觀組織觀察，確定了3個不同區域的高溫變形機制：溫度900~1030 ℃、應變速率小于0.1 s-1時，變形機制為動態回復和連續動態再結晶；溫度大于1030 ℃、應變速率小于0.1 s-1時，功率耗散效率η出現峰值，除了動態回復和連續動態再結晶，還出現碳化物溶解現象；高應變速率（大致在0.01~1 s-1之間）區，是合金的變形失穩區域，較低溫度時失穩機制為局部流動，高溫失穩與碳化物溶解有關，=1 s-1時組織演變特征是項鏈狀動態再結晶

    Abstract:

    Hot compressive deformation tests of as-cast burn resistant titanium alloy (Ti-35V-15Cr-Si-C) were performed on the Gleeble-1500 simulator in the temperature range of 900~1200 °C, over the range of strain rate from 10-3 s-1 to 1 s-1. The compressive true stress vs. true strain curves were measured. The discontinuous yielding phenomenon was explained. The hot processing maps developed on the basis of dynamic material model (DMM) exhibits the following three domains. The alloy dynamic recovery and continuous recrystallization in the temperature range from 900 °C to 1030 °C and at lower strain rate (＜0.1 s-1). A peak power dissipation efficiency area of 50%~65% occurring at higher temperature (≥1030 °C) and lower strain rate. In addition to dynamic recovery and continuous recrystallization, the carbide solution phenomenon is observed. The alloy exhibits a wide region of flow instability manifested by flow localization and carbide solution at higher strain rate. The ‘Necklace’ dynamic recrystallization occurs at the strain rate of 1 s-1

    參考文獻
    相似文獻
    引證文獻
引用本文

孫歡迎,曹京霞,王 寶,黃 旭,曹春曉.鑄態阻燃鈦合金的熱加工圖與變形機制研究[J].稀有金屬材料與工程,2013,42(12):2541~2546.[Sun Huanying, Cao Jingxia, Wang Bao, Huang Xu, Cao Chunxiao. Hot Processing Map and Deformation Mechanism of as-Cast Burn Resistant Titanium Alloy[J]. Rare Metal Materials and Engineering,2013,42(12):2541~2546.]
DOI：[doi]

復制
文章指標
  • 點擊次數:
  • 下載次數:
  • HTML閱讀次數:
  • 引用次數:
歷史
  • 收稿日期:2012-12-10
  • 最后修改日期:
  • 錄用日期:
  • 在線發布日期:
  • 出版日期: