最新色国产精品精品视频,中文字幕日韩一区二区不卡,亚洲有码转帖,夜夜躁日日躁狠狠久久av,中国凸偷窥xxxx自由视频

+高級檢索
TC18合金β相區等溫鍛造顯微組織和力學性能
DOI:
作者:
作者單位:

作者簡介:

通訊作者:

中圖分類號:

基金項目:


Microstructure and Mechanical Properties of β Isothermal Forged TC18 Alloy
Author:
Affiliation:

Fund Project:

  • 摘要
    • |
  • 圖/表
    • |
  • 訪問統計
    • |
  • 參考文獻
    • |
  • 相似文獻
    • |
  • 引證文獻
    • |
  • 資源附件
    • |
  • 文章評論
    摘要:

    研究了β相區等溫變形溫度、變形程度對TC18鈦合金顯微組織和力學性能的影響，討論了工藝、組織和性能之間的關系。結果表明，TC18合金顯微組織對等溫鍛造溫度的變化比較敏感，兩相區等溫鍛造和單相區等溫鍛造的顯微組織分別為雙態組織和網籃組織；與兩相區鍛造相比，β相區鍛造獲得了更高的強度和斷裂韌性，但塑性有所降低，且隨著變形溫度的升高，強度和塑性均呈現下降趨勢，斷裂韌性稍有升高。β相區變形量較小時，組織遺傳性導致合金保留了部分魏氏組織形貌，塑性較低，斷裂韌性較高；當變形量達到60%時，晶粒破碎程度大，次生片狀α相發生一定程度球化并彌散分布，組織變得均勻細小，合金強度和塑性保持良好的匹配，斷裂韌性較高，綜合性能最好

    Abstract:

    The effects of deformation temperature and deformation degree on the microstructure and mechanical properties of TC18 titanium alloy during the β isothermal forging were studied. Results show that the microstructure of TC18 titanium alloy is sensitive to the variation of isothermal forging temperature. Deforming in (α+β)-phase gets a typical bi-modal microstructure while deforming in β-phase gets a net-shaped microstructure. When deforming above the β-transus temperature, the forging shows higher strength, fracture toughness and lower plasticity. With higher deformation temperature, both the strength and the plasticity decrease while the fracture toughness increases a little. Deforming above the β-transus temperature, typical Widmanstatten, coarse β grains, and the highest fracture toughness are obtained in small deformation degree. When the deformation degree reaches 60%, grains crack seriously, secondary lamellar α further globalize and disperse, and the microstructure becomes even fine, so the alloy’s strength and plasticity maintain good matching, fracture toughness is better and the best comprehensive properties are achieved

    參考文獻
    相似文獻
    引證文獻
引用本文

張永強,郭鴻鎮,劉 瑞,王 濤,趙張龍,姚澤坤. TC18合金β相區等溫鍛造顯微組織和力學性能[J].稀有金屬材料與工程,2013,42(3):634~638.[Zhang Yongqiang, Guo Hongzhen, Liu Rui, Wang Tao, Zhao Zhanglong, Yao Zekun. Microstructure and Mechanical Properties of β Isothermal Forged TC18 Alloy[J]. Rare Metal Materials and Engineering,2013,42(3):634~638.]
DOI：[doi]

復制
文章指標
  • 點擊次數:
  • 下載次數:
  • HTML閱讀次數:
  • 引用次數:
歷史
  • 收稿日期:2012-02-17
  • 最后修改日期:
  • 錄用日期:
  • 在線發布日期:
  • 出版日期: