最新色国产精品精品视频,中文字幕日韩一区二区不卡,亚洲有码转帖,夜夜躁日日躁狠狠久久av,中国凸偷窥xxxx自由视频

+高級檢索
粉末粒度對SPS固相燒結La0.6Eu0.4B6陰極材料的影響
DOI:
作者:
作者單位:

作者簡介:

通訊作者:

中圖分類號:

基金項目:

國家自然科學基金項目(50871002)


Effect of Particle Size on the Solid-Phase Sintered Polycrystalline La0.6Eu0.4B6 Cathode Prepared by Spark Plasma Sintering
Author:
Affiliation:

Fund Project:

  • 摘要
    • |
  • 圖/表
    • |
  • 訪問統計
    • |
  • 參考文獻
    • |
  • 相似文獻
    • |
  • 引證文獻
    • |
  • 資源附件
    • |
  • 文章評論
    摘要:

    采用高能球磨法制備出La0.6Eu0.4B6納米粉體，將球磨后的納米粉進行放電等離子（SPS）燒結，制備出了高致密的La0.6Eu0.4B6多晶塊體材料。系統研究了燒結溫度、燒結壓力對樣品致密度和力學性能的影響。結果表明，該方法與傳統熱壓燒結方法相比有效降低了燒結溫度，制備出的樣品密度、維氏硬度和抗彎強度分別達到4.71 g/cm3、23.37 GPa和295.14 MPa，這些值均高于傳統熱壓燒結方法。熱電子發射結果表明，當陰極溫度為1873 K時，最大發射電流密度為33.74 A/cm2。實驗過程中還發現，在相同燒結工藝下，球磨納米粉與粗粉相比，維氏硬度、抗彎強度和熱電子發射電流密度分別提高了28%、58%和32%。因此，在固相燒結過程中，粉末粒度的減小，更有助于燒結性能的提高。

    Abstract:

    The La0.6Eu0.4B6 nanopowders were prepared by high-energy ball milling, and then the ball-milled nanopowder were used to prepare the high-density La0.6Eu0.4B6 polycrystalline bulks by spark plasma sintering (SPS). The influence of sintering temperature and pressure on the sample density and mechanical properties were investigated. The results show that this method reduces the sintering temperature more effectively than the conventional hot-pressing method. The sample density, Vickers hardness and flexural strength are 4.71 g/cm3, 23.37 GPa, and 295.14 MPa, respectively, which ??are also higher than those of conventional hot-pressing methods. The thermionic emission results show that when the cathode temperature is 1873 K, the maximum emission current density of La0.6Eu0.4B6 is 33.74 A/cm2. Under the same sintering condition, the Vickers hardness, flexural strength and thermionic emission current density of ball-milled nanopowder are increased by 28%, 58% and 32% compared with coarse-powder-sintered sample. These results indicate that refining the powder grain size to nano level is beneficial for reducing the sintering temperature and promoting the thermionic emission and mechanical properties.

    參考文獻
    相似文獻
    引證文獻
引用本文

張 寧,張久興,包黎紅,魏永峰,李曉娜.粉末粒度對SPS固相燒結La0.6Eu0.4B6陰極材料的影響[J].稀有金屬材料與工程,2013,42(2):311~315.[Zhang Ning, Zhang Jiuxing, Bao Lihong, Wei Yongfeng, Li Xiaona. Effect of Particle Size on the Solid-Phase Sintered Polycrystalline La0.6Eu0.4B6 Cathode Prepared by Spark Plasma Sintering[J]. Rare Metal Materials and Engineering,2013,42(2):311~315.]
DOI：[doi]

復制
文章指標
  • 點擊次數:
  • 下載次數:
  • HTML閱讀次數:
  • 引用次數:
歷史
  • 收稿日期:2012-02-13
  • 最后修改日期:
  • 錄用日期:
  • 在線發布日期:
  • 出版日期: