最新色国产精品精品视频,中文字幕日韩一区二区不卡,亚洲有码转帖,夜夜躁日日躁狠狠久久av,中国凸偷窥xxxx自由视频

+高級檢索
等溫變形對異種鈦合金焊縫組織性能的影響
DOI:
作者:
作者單位:

作者簡介:

通訊作者:

中圖分類號:

基金項目:

國家自然科學基金資助項目(50775187)


Influence of Isothermal Deformation Parameters on Microstructures and Properties of Welded Zone of Dissimilar Titanium Alloy
Author:
Affiliation:

Fund Project:

  • 摘要
    • |
  • 圖/表
    • |
  • 訪問統計
    • |
  • 參考文獻
    • |
  • 相似文獻
    • |
  • 引證文獻
    • |
  • 資源附件
    • |
  • 文章評論
    摘要:

    通過改變等溫變形工藝參數探討了焊縫顯微組織的變化機理與焊件的室溫拉伸性能。結果表明：在較低應變速率下，以較大變形量變形時，焊接界面晶粒細化與位錯切過晶界和晶內的O/α2相條及O/α2發生拉長、頸縮而斷開的機制有關，變形量小時則主要以位錯切斷晶界及晶內O/α2條為主。應變速率低(10-4 s-1)和高(10-2 s-1)時，出現的粗細不同條狀O/α2相是與動態再結晶的響應速率有關。在980 ℃，以10-2～10-4 s-1應變速率和30%～50%變形Ti2AlNb/TC11雙合金焊接接頭，可得到高于TC11合金的室溫強度

    Abstract:

    The evolution mechanism of the weld zone microstructure and the room temperature tensile strength of the weldment for Ti2AlNb/TC11 dissimilar alloy were investigated through changing the isothermal deformation parameters. Results show that at lower strain rate with higher deformation, the grain refinement of the welded interface is related to dislocation cutting across grain boundary and intragranlar strip O/α2-phase and elongated O/α2-phase necking down. With low deformation, the grain refinement is only related to dislocation cutting across the grain-boundaries and transgranular strip O/α2-phases. Appearance of course and fine strip O/α2-phases is related to response of dynamic recrystallization at low strain rate (10-4 s-1) and high strain rate (10-2 s-1). After hot deformation at 980 °C, at strain rate of 10-2-10-4 s-1 and deformation of 30%-50%, the room-temperature strength of the Ti2AlNb/TC11 dual-alloy joint is better than that of TC11 alloy

    參考文獻
    相似文獻
    引證文獻
引用本文

周 偉,姚澤坤,譚立軍,郭鴻鎮,張建偉,梁曉波.等溫變形對異種鈦合金焊縫組織性能的影響[J].稀有金屬材料與工程,2011,40(7):1230~1233.[Zhou Wei, Yao Zekun, Tan Lijun, Guo Hongzhen, Zhang Jianwei, Liang Xiaobo. Influence of Isothermal Deformation Parameters on Microstructures and Properties of Welded Zone of Dissimilar Titanium Alloy[J]. Rare Metal Materials and Engineering,2011,40(7):1230~1233.]
DOI：[doi]

復制
文章指標
  • 點擊次數:
  • 下載次數:
  • HTML閱讀次數:
  • 引用次數:
歷史
  • 收稿日期:2010-07-11
  • 最后修改日期:
  • 錄用日期:
  • 在線發布日期:
  • 出版日期: