最新色国产精品精品视频,中文字幕日韩一区二区不卡,亚洲有码转帖,夜夜躁日日躁狠狠久久av,中国凸偷窥xxxx自由视频

+高級檢索
等通道轉角擠壓工藝對TA15合金顯微硬度的影響
DOI:
作者:
作者單位:

作者簡介:

通訊作者:

中圖分類號:

基金項目:


Effects of Equal Channel Angular Pressing on Microhardness of TA15 Alloy
Author:
Affiliation:

Fund Project:

  • 摘要
  • |
  • 圖/表
  • |
  • 訪問統計
  • |
  • 參考文獻
  • |
  • 相似文獻
  • |
  • 引證文獻
  • |
  • 資源附件
  • |
  • 文章評論
    摘要:

    研究近α鈦合金TA15經等通道轉角擠壓工藝(ECAP)加工后的維氏顯微硬度及其變化規律。結果表明:TA15合金經ECAP擠壓后,顯微硬度顯著提高,且合金試樣外層硬度略高于芯部。合金的顯微硬度與組織畸變程度、位錯密度、晶粒尺寸以及相組成等密切相關。相變點以下擠壓,擠壓溫度越低,硬度越高;相變點以上擠壓,由于擠壓后水冷過程中在β相內產生針狀馬氏體α′,硬度明顯高于相變點以下擠壓。模具轉角越小,顯微硬度越高。隨擠壓次數增加,硬度先增大后保持基本不變,而擠壓路徑對硬度的影響與擠壓次數、擠壓后細化效果密切相關。TA15合金經ECAP后退火,顯微硬度明顯降低

    Abstract:

    Vickers microhardness of TA15 titanium alloy after equal channel angular pressing (ECAP) and its variation was investigated. The results indicate that the microhardness is increased observably after ECAP, and the microhardness level of the outer layer is slightly higher than that of the core in the same cylinder sample. The microhardness of ECAPed alloy is closely related to microstructure distortion, dislocation density, grain size and phase composition. There is a decrease in microhardness with the increasing pressing temperature below Tβ. As a result of the acicular martensite precipitation, the microhardness after ECAP above Tβ is much higher than that below Tβ. A lower die angle means a better hardness. The microhardness increases first and then remains at a certain level with the increasing passes, while the route effects on hardness are related to the pass number and the refinement effects. The annealing after ECAP can effectively reduce the microhardness

    參考文獻
    相似文獻
    引證文獻
引用本文

趙 嚴,郭鴻鎮,王 濤,譚立軍,姚澤坤.等通道轉角擠壓工藝對TA15合金顯微硬度的影響[J].稀有金屬材料與工程,2011,40(5):885~888.[Zhao Yan, Guo Hongzhen, Wang Tao, Tan Lijun, Yao Zekun. Effects of Equal Channel Angular Pressing on Microhardness of TA15 Alloy[J]. Rare Metal Materials and Engineering,2011,40(5):885~888.]
DOI:[doi]

復制
文章指標
  • 點擊次數:
  • 下載次數:
  • HTML閱讀次數:
  • 引用次數:
歷史
  • 收稿日期:2010-05-18
  • 最后修改日期:
  • 錄用日期:
  • 在線發布日期:
  • 出版日期: