最新色国产精品精品视频,中文字幕日韩一区二区不卡,亚洲有码转帖,夜夜躁日日躁狠狠久久av,中国凸偷窥xxxx自由视频

+高級檢索
放電等離子燒結溫度對鎢合金的組織及動態力學性能的影響
DOI:
作者:
作者單位:

作者簡介:

通訊作者:

中圖分類號:

基金項目:


Effects of Spark Plasma Sintering Temperature on Microstructure and Dynamic Mechanical Properties of 93W-4.9Ni-2.1Fe Alloy
Author:
Affiliation:

Fund Project:

  • 摘要
    • |
  • 圖/表
    • |
  • 訪問統計
    • |
  • 參考文獻
    • |
  • 相似文獻
    • |
  • 引證文獻
    • |
  • 資源附件
    • |
  • 文章評論
    摘要:

    以納米93W-4.9Ni-2.1Fe 合金粉末為原料，研究放電等離子燒結溫度對鎢合金組織和動態力學性能的影響。結果表明，采用放電等離子燒結方法可制備出組織均勻的細晶鎢合金。當燒結溫度在950~1400 ℃時，隨著燒結溫度的增加，鎢顆粒平均尺寸由2 μm增大到10 μm，試樣動態抗壓強度隨之降低；動態壓縮過程中，燒結溫度在1000~1200 ℃的試樣塑性均較好，而當燒結溫度超過1300 ℃時，試樣的塑性很低，表現為明顯的脆性狀態

    Abstract:

    The effects of the spark plasma sintering temperature on microstructure and dynamic mechanical properties of the tungsten heavy alloy with nano-crystalline 93W-4.9Ni-2.1Fe alloy powder as raw material were investigated. Results show that ultra-fine tungsten alloy with uniform microstructure can be prepared by the spark plasma sintering technology. In the sintering temperature range between 950 oC and 1400 oC, the average particle size of the tungsten heavy alloy increases from 2 μm to 10 μm with the sintering temperature elevation while the dynamic compressive strength decreases accordingly. During the process of dynamic compression the plasticity of samples sintered at the temperature between 1000 oC and 1200 oC is good. However, dynamic plasticity of samples sintered at the temperature between 1300 oC and 1400 oC is almost zero, showing typical brittle failure

    參考文獻
    相似文獻
    引證文獻
引用本文

王迎春,李樹奎,王富恥,羅鴻志.放電等離子燒結溫度對鎢合金的組織及動態力學性能的影響[J].稀有金屬材料與工程,2010,39(10):1807~1810.[Wang Yingchun, Li Shukui, Wang Fuchi, Luo Hongzhi. Effects of Spark Plasma Sintering Temperature on Microstructure and Dynamic Mechanical Properties of 93W-4.9Ni-2.1Fe Alloy[J]. Rare Metal Materials and Engineering,2010,39(10):1807~1810.]
DOI：[doi]

復制
文章指標
  • 點擊次數:
  • 下載次數:
  • HTML閱讀次數:
  • 引用次數:
歷史
  • 收稿日期:2009-10-16
  • 最后修改日期:
  • 錄用日期:
  • 在線發布日期:
  • 出版日期: