最新色国产精品精品视频,中文字幕日韩一区二区不卡,亚洲有码转帖,夜夜躁日日躁狠狠久久av,中国凸偷窥xxxx自由视频

+高級檢索
梯度熱處理對Ti3Al/TC11雙合金焊接界面組織和顯微硬度的影響
DOI:
作者:
作者單位:

作者簡介:

通訊作者:

中圖分類號:

基金項目:


Influence of Gradient Heat Treatment on Microstructure and Microhardness in Weld Seam of Ti3Al/TC11 Dual Alloys
Author:
Affiliation:

Fund Project:

National Natural Science Foundation of China (50775187)

  • 摘要
    • |
  • 圖/表
    • |
  • 訪問統計
    • |
  • 參考文獻
    • |
  • 相似文獻
    • |
  • 引證文獻
    • |
  • 資源附件
    • |
  • 文章評論
    摘要:

    研究經近等溫變形的Ti3Al/TC11雙合金在梯度熱處理前后,焊接界面顯微組織和顯微硬度的變化。結果表明，Ti3Al側熱影 響區的顯微組織在梯度熱處理前后變化較小是因?yàn)榫Ы绂?相較穩定；焊縫區顯微組織變化較大，究其原因是近等溫變形造成的晶粒破碎和Ti、Al、Nb等原子的擴散，造成α、α2相互制衡，致使不能形成連續晶界α2或晶界α；TC11合金基體經過梯度熱處理后從網籃組織轉變成等軸組織；顯微硬度的提高是因?yàn)門i、Al、Nb擴散，造成α、α2尺寸小、彌散分布所致。

    Abstract:

    The changes of the microstructure and the microhardness at the weld interface of near isothermally forged Ti3Al/TC11 dual alloys before and after gradient heat treatment were investigated. The results indicate that the stability of α2 phase and distribution in the grain boundary results in slight changes of microstructures at heat-affected zone on Ti3Al side, but the changes of the microstructure in the weld zone are relatively obvious due to the diffusions of elements such as Ti, Al, Nb and so on. Because growing-up of the α and α2 phase is restricted each other, the continual α or α2 phase grain boundary can not be formed. After gradient heat treatment, the matrix microstructure of the TC11 alloy changes from basketweave structure to equiaxed structure. Because of the diffusions of Ti, Al and Nb, the sizes of α and α2 phases become small and their distribution become dispersive, resulting in the increase in microhardness.

    參考文獻
    相似文獻
    引證文獻
引用本文

楊航航,姚澤坤,高 峻,郭鴻鎮,劉瑩瑩,王 敏.梯度熱處理對Ti3Al/TC11雙合金焊接界面組織和顯微硬度的影響[J].稀有金屬材料與工程,2010,39(1):22~26.[Yang Hanghang, Yao Zekun, Gao Jun, Guo Hongzhen, Liu Yingying, Wang Min. Influence of Gradient Heat Treatment on Microstructure and Microhardness in Weld Seam of Ti3Al/TC11 Dual Alloys[J]. Rare Metal Materials and Engineering,2010,39(1):22~26.]
DOI：[doi]

復制
文章指標
  • 點擊次數:
  • 下載次數:
  • HTML閱讀次數:
  • 引用次數:
歷史
  • 收稿日期:2009-01-15
  • 最后修改日期:
  • 錄用日期:
  • 在線發布日期:
  • 出版日期: