最新色国产精品精品视频,中文字幕日韩一区二区不卡,亚洲有码转帖,夜夜躁日日躁狠狠久久av,中国凸偷窥xxxx自由视频

預應變時效對Ti-2.5Cu合金力學性能的影響
DOI:
作者:
作者單位:

作者簡介:

通訊作者:

中圖分類號:

基金項目:

國家自然科學基金資助項目(51501067); 棗莊學院博士基金資助項目(2018BS062)


Effects of Prestrain and Aging on Mechanical Properties of Ti-2.5Cu Alloy
Author:
Affiliation:

Fund Project:

  • 摘要
    • |
  • 圖/表
    • |
  • 訪問統計
    • |
  • 參考文獻
    • |
  • 相似文獻
    • |
  • 引證文獻
    • |
  • 資源附件
    • |
  • 文章評論
    摘要:

    對固溶處理后的Ti-2.5Cu合金分別施加0.05、0.1、0.15、0.2的拉伸預應變,隨后進行一次時效(400℃×24 h/AC)和二次時效處理(475℃×8 h/AC),研究了預應變時效處理對Ti-2.5Cu合金拉伸性能和低周疲勞性能的影響。結果表明:二次時效后析出的Ti_2Cu粒子尺寸較一次時效有了明顯的長大;一次時效處理的合金強度隨預應變量的增加而升高,而二次時效處理的合金強度隨預應變量的增加先增加,當預應變量超過0.15后,開始下降;2種時效工藝處理的合金延伸率均保持在較高的水平。在考慮應變回復的基礎上,建立了Ti-2.5Cu合金預應變時效的強度預測模型,其理論預測值與實驗結果相吻合;一次時效和二次時效后的疲勞壽命相當,都表現為循環軟化,疲勞裂紋以穿晶方式擴展。通過預應變時效處理可以提高Ti-2.5Cu合金的綜合力學性能。

    Abstract:

    After solution treatment,prestrains with 0.05, 01, 0.15 and 0.2 were applied to Ti-2.5 Cu alloy samples followed by first(400 ℃×24 h/AC) and second(475 ℃×8 h/AC) aging treatments and the corresponding tensile and low cycle fatigue(LCF) behaviors were investigated. The results show that the larger Ti_2Cu particles are observed after the second aging compared to the first aging. The yield strength increases with the prestrains for the first aging. Whereas the strength firstly increases with the prestrain while reduction in strength is observed when prestrain exceeds 0.15 for the second aging. Meanwhile, elongation of pretrained and aged Ti-2.5 Cu samples keeps in a same level with those unstrained ones. Considering strain recovery, the strength model of Ti-2.5 Cu alloy with prestrain and aging is established, which is in well agreement with experimental results. LCF results show that the similar LCF life and cycle softening are observed for both aging treatments. The fractography analyses suggest that transgranular fracture with well developed fatigue striations is the predominant failure mode. It can be concluded that the process of prestrain followed by aging is a useful method to obtain good mechanical properties of Ti-2.5 Cu alloy.

    參考文獻
    相似文獻
    引證文獻
引用本文

.預應變時效對Ti-2.5Cu合金力學性能的影響[J].鈦工業進展,2019,36(6):24-30.

復制
分享
文章指標
  • 點擊次數:
  • 下載次數:
  • HTML閱讀次數:
  • 引用次數:
歷史
  • 收稿日期:
  • 最后修改日期:
  • 錄用日期:
  • 在線發布日期: 2020-02-17
  • 出版日期: