最新色国产精品精品视频,中文字幕日韩一区二区不卡,亚洲有码转帖,夜夜躁日日躁狠狠久久av,中国凸偷窥xxxx自由视频

冷加工率對Ti-35合金組織性能的影響
DOI:
作者:
作者單位:

作者簡介:

通訊作者:

中圖分類號:

TF124.1 TG146

基金項目:


Effect of Cold Processing Rate on the Microstructure and Mechanical Properties of Ti-35 Alloy
Author:
Affiliation:

Fund Project:

  • 摘要
    • |
  • 圖/表
    • |
  • 訪問統計
    • |
  • 參考文獻
    • |
  • 相似文獻
    • |
  • 引證文獻
    • |
  • 資源附件
    • |
  • 文章評論
    摘要:

    研究了冷加工率對Ti-35鈦合金板材組織性能的影響。結果表明：Ti-35鈦合金板材隨著冷加工率的增加，拉伸強度增高，塑性下降，這是符合一般規律的。然而，當冷變形率達80％，塑性仍然保持在16％，證明這是一種高塑性合金，隨著冷變形量增加，晶粒被拉長。當變形率達60％～80％時，晶粒呈纖維化，經退火后發生再結晶，晶粒等軸化，并伴隨著合金塑性的提高。

    Abstract:

    Effect of cold processing on the microstructure and mechanical properties of Ti-35 alloy plate was studied. It was found that the tensile strength increased, while the ductility decreased with the increase of cold deformation strain, which confirms the general principles. However, remaining of the ductility of 16% with cold deformation of 80% proves the high plasticity of the alloy. When deformation rate was between 60%~80%, grains became fiber. Recrystallization occurred after annealing. Grains became equiaxed with the increase of plasticity of the alloy.

    參考文獻
    相似文獻
    引證文獻
引用本文

.冷加工率對Ti-35合金組織性能的影響[J].鈦工業進展,2004,21(6):22-24.

復制
分享
文章指標
  • 點擊次數:
  • 下載次數:
  • HTML閱讀次數:
  • 引用次數:
歷史
  • 收稿日期:
  • 最后修改日期:2004-08-24
  • 錄用日期:
  • 在線發布日期:
  • 出版日期: